6 hrs to go - urgent advice please

[chunder]

Has anyone seen anything like this before ?

[http://cgi.ebay.com.au/ws/eBayISAPI.d]

I have been toying with the idea of buying a couple of plenum's and welding up a twin set up - this looks like a kind of half way house but what's with the ram tubes ?

Any advice welcome, thanks.

[rev-erend]

Looks pretty standard to me - perhaps that's just what the Aussies call them..

[350matt]

The only thing thats unusual about it is the water inlet, without taking the plenum off it looks std and if so, is no way worth that amount

Flows 330 bhp my bum....


If you do make your own twin plenum, DO NOT weld two plenums down the middle to give a throttle on either side as this actually results in less power than std. As the incoming air streams collide with one another and cause massive turbulance.

Far cheaper to slice off the std intake and weld on a twin Ford V6 2.9 Cologne throttle body

Matt

[chassis 33]

Is this the beast you're on about?
http://cgi.ebay.co.uk/ford-scorpio-ul

What diameter at the butterflies?

Regards
Iain

Edited for gramma.

Edited by chassis 33 on Thursday 3rd August 12:52

[chunder]

rev-erend said:

Looks pretty standard to me - perhaps that's just what the Aussies call them..

I've only just learnt what extractors are !

I don't think it's standard because it looks like the round inlet opens up into a kind of flattened triangle shape much wider than the standard which dosn't open up much until close to tha actual plenum chamber - not much different though granted.

[chunder]

Thanks for the advice - I didn't bother with it !