Discussion
Ok going to check out the Griff Rads at leven,
Had to pretend I had a griff, as 1st time I spoke to them they was not interested in speaking to me.
but posted a pic of the griff forum and they say my rad is the same as there's
So going down tonight to check one out.
I can't belive they are only 1 mile from my house. else I'd tell them where to stick it.
Had to pretend I had a griff, as 1st time I spoke to them they was not interested in speaking to me.
but posted a pic of the griff forum and they say my rad is the same as there's
So going down tonight to check one out.
I can't belive they are only 1 mile from my house. else I'd tell them where to stick it.
Ok the Griff Rad is the same as the 400SE rad.
And the Ali one will fit, will need to make new Oil cooler brackets, plus use the bleed take too for the header tank.
It had a front mounted screw in otter switch so that will make things a bit easier.
but after that it should fit fine.
Will be picking it up tomorrow.
It is designed to take two Griff 12" fans so that's going to add to the cost.
I may wire one up as current system on the otter switch,
And put the other on a manual switch.
And the Ali one will fit, will need to make new Oil cooler brackets, plus use the bleed take too for the header tank.
It had a front mounted screw in otter switch so that will make things a bit easier.
but after that it should fit fine.
Will be picking it up tomorrow.
It is designed to take two Griff 12" fans so that's going to add to the cost.
I may wire one up as current system on the otter switch,
And put the other on a manual switch.
Edited by TVRleigh on Monday 13th August 18:36
Gassing Station | Wedges | Top of Page | What's New | My Stuff