SEAC Window question

[NHyde]

My drivers window is badly out of adjustment/ alignment , to the extent that with he window fully up the door not shut with the the roof on .

The door shuts easliy , and is well aligned , and the window operates well and smoothly ,at the forward edge the angle of glass and door frame matches and there are no gaps .

Have checked the bible , without success . Does any one know if the SEACs have different windows than the other wedges ? Have already discovered during my recent screen change , that it had the wrong one fitted then , and am suspicious .

Any suggestions appreciated

[2 sheds]

I'm sure all wedges have the same windows / mechanisms, I would have thought its just a case of adjustments to the position of the motor assembly, have never done this, but hopefully somebody here will have more experience.
Tim

[jmorgan]

Bike brake cable needs adjusting? Limits the travel up. Clamp on the cable behind the door trim.

[dickymint]

Check out "wedge doors explained" in the maintenace section of this site. May help.

[streaky]

dickymint said:

Check out "wedge doors explained" in the maintenace section of this site. May help.

Forgive me for being stupid, but where's the 'maintenance section of this site' - I can't see one listed

[york33]

I would suspect he means 'ere:

www.bress.freeserve.co.uk/wedge/maint_doors.html

You can read PH (Wedge) forums through that site too, which could explain the confusion.......

HTH
Dave

[streaky]

york33 said:

I would suspect he means 'ere: www.bress.freeserve.co.uk/wedge/maint_doors.html You can read PH (Wedge) forums through that site too, which could explain the confusion....... HTH Dave

I know that site, confusion explained. Thx - S

[sevans]

Had the same problem with the rear of the drivers (NS) window hitting the roof. This is on an 83 Tasmin, so it would seem a common problem. Tried a few things to rectify it including shorting the cable but this just seemed to lower the height of the whole window so there was now a gap at the front edge. I also had a problem with the roof being bowed (high in the middle) I noticed if you push down on the middle of the roof then the outer edges lift. I corrected this but the window still hit the roof slightly so I resorted to taking off the edge of the roof. May not help you if you don't want to recover your roof. I am not sure there is an easy fix........