Heater Controls sticker
Discussion
I am thinking of having some heater legend stickers made for the S Series - but I think there may also be a similar arrangement on the Wedge?
It would not have the steps you can see between the red & blue - thats as good as I can show it as a jpg.
Everyones thoughts on this appreciated.
It would have a black background as shown.
The resin style badge edges taper off - so it would not have a step at the edges.
Also - are the blower positions correct for a wedge - to to the left is to screen and right is feet, and similarly hot to the right cold to the left.
Option1
Option2 (No silver on temp graphic - I like this best personally)
Chris
- ETA I've just had a look at the dash in the classifieds - I think it might work on the 400SE style dash but not the normal wedge 'stepped' dash.
It would not have the steps you can see between the red & blue - thats as good as I can show it as a jpg.
Everyones thoughts on this appreciated.
It would have a black background as shown.
The resin style badge edges taper off - so it would not have a step at the edges.
Also - are the blower positions correct for a wedge - to to the left is to screen and right is feet, and similarly hot to the right cold to the left.
Option1
Option2 (No silver on temp graphic - I like this best personally)
Chris
Edited by Barkychoc on Monday 15th December 17:20
Should fit the 400se 
See recent post here for pics of the same sticker configeration in a wedge:
http://www.pistonheads.com/gassing/topic.asp?h=0&a...
See recent post here for pics of the same sticker configeration in a wedge:
http://www.pistonheads.com/gassing/topic.asp?h=0&a...
Yep thats the same sticker as the S - the only problem is that the heater sliders are closer together on the S - so the heater sticker has to be only 9mm high to fit between the sliders on the S.
That original sticker fits under the original sliders at the edges but the resin type I was looking to have manufactured is thicker so it won't go under on the S - hence the need to go 9mm high.
If anyone is interested and there's a bit of interest on the S forum I'll get some pricing together to see if it is viable (mods there is no way this is commercial as I make nothing out of it).
That original sticker fits under the original sliders at the edges but the resin type I was looking to have manufactured is thicker so it won't go under on the S - hence the need to go 9mm high.
If anyone is interested and there's a bit of interest on the S forum I'll get some pricing together to see if it is viable (mods there is no way this is commercial as I make nothing out of it).
Gassing Station | Wedges | Top of Page | What's New | My Stuff