400SE jacking points.

[MR2dave]

This makes me sound like a div' but, where are the correct jacking points on a 400?

Mine has lost it's manual you see. I want to hammerite the chassis this weekend but i don't want to bend the outriggers.

Toyota's have little cut outs and arrows to help with techincal matters like this.....

[danny hoffman]

I always jack mine under the cross beam below the engine and the large U section beam under the diff.

I would never jack on any of the tubes

[Planman350i]

I use the main cross member at the front. At the back I usually go for the main longitudinal tubes on either side of the chassis at a point forward of the diff, where various other chassis tubes converge.

I think you will find there are lots of other variations on this though!

[Seamus]

I may have lost it this early in the morning, but I think there are 4 plates on the 400s, one at each end of the outriggers which the car can be lifted on..