SEC BODY PARTS

[mac123yre]

I have a standard 350i that will be getting a re-spray in the winter, I would like to put a boot spoiler on and a rear splitter below the bumper, where can I acquire these any ideas, is there a retro parts shop I can get the bits from.

Regards: Mac

[red tasman]

Try T.E.T Mouldings.

[Gandalf]

Trevor Bee at TET will sort you out Mac

http://www.b-link.co.uk/tet/

[lancia4wd]

I have a SEAC fiberglass rear spoiler and also the mould to make others, looking for £150 for the spoiler delivered to uk.


Needs enginering to the mounting of it.

Regards


Nick

[mac123yre]

managed to find a spoiler but still need the rear spliter for under the bumper?

[grahamw48]

Do you mean the surf board thing slung under the back, as per the 390 and 400+ SEs ?

[mac123yre]

yes I do do you know where I can get one?

[Number 7]

mac123yre said:

yes I do do you know where I can get one?

No idea, but they were integral with the body on the 400 / 450 series. I believe that some early 390's had seperate bolt-on mouldings though.

7.

[grahamw48]

Yes, the S1 390SE had the bolt-on type (as per Wedg1e's car).

Not sure whether it could be made to fit a 350 though.

[mac123yre]

am gona make one out of blue foam and make a mold to fit 350i

[grahamw48]

Better keep the mould.... you might get a few orders.

[mac123yre]

When I go to bng will take some pics and take me tape measure

[firefox1712]

Someone told me that the separate rear underwing as under 390s etc was so heavy it was a two man job to get off on his car! I didn't try it with my car!

I would also think you would need to cut away some of the rear body too.

The rear underwing on the 400 SE syle body was a false one with only the external edges actually carrying any air over them. Most off the length of the wing was blanked off/filled in to merge with the rest of the rear body - a styling device.

The 350 body is also different in that it doesn't have the slightly flared wings.

JJ