Just had mikeyb on the phone................

[dickymint]

He was too embarrassed to post - "where the frack is the bonnet release on a SEAC" Answers on a postcard please

[Campbell]

dickymint said:

He was too embarrassed to post - "where the frack is the bonnet release on a SEAC" Answers on a postcard please

Ohh mikeb dosnt know where the bonnet releace catch is.... ohh dear.



Too much ill get me

[stainless_steve]

Mike,try looking on the bonnet

[GV]

Oh no...!

[2 sMoKiN bArReLs]

dickymint said:

He was too embarrassed to post - "where the frack is the bonnet release on a SEAC" Answers on a postcard please

you dobber!

[mikeb]

....In the most supidest place possible!! Never seen such nonsense

In the 350i and 450 in the lower side of the drivers column - where you would expect. In the SEAC, oh no, behind the bleeding dashboard!

Dicky had to think for five minutes for him to remember mind! ;-)

.....I'll get me coat.

MikeyB

[mikeb]

Campbell where is it on yours?

[Campbell]

mikeb said:

Campbell where is it on yours?

Hi Mikeb

mine is in the passenger foot well just above the ECU, you can just see the red pull handel tucked in there, my bonnet catch is in the middle, most of the wedges ive seen have them off set from centre.

Cambelt

[Mr Tank]

Hi

Bonnett pulls are a typical TVR thing.

The wifes 280i bonnet pull is under the dash by the edge of the drivers door. The catch is on the nearside of the engine compartment bulkhead. This is identical places to my old series 2 350i. Whilst my 350i (num 1) the bonnet pull is in the same place, but the catch is in the middle of the bulkhead.
Then my SEAC, the pull is under the dash on the nearside next to the ECU and the bonnet catch is in the middle of the baulkhead!

So take you pick!

Andy

[rev-erend]

Mike

Just do what I do .. leave the bonnet off.

Saves all that searching around for a bonnet pull