SEAC nearside indicator bulb change

[cuneus]

This look pretty inaccessible - any tips or tricks ?
How long does the job take ?

TIA

[Campbell]

Can you not take off the perspex cover or is yours silicon on.
Mine is held on with 6 self taper screws as ive had to replace it as the old one was damaged with stone chips.
I would be looking to remove the plastic and then its dead easy to replace the bulbs and was the covers.
There isnt any other way to replace any of the bulbs.
Good luck.

Cambelt

[adam quantrill]

I've never done it but Offord did it during a service and they went in through the front. You need some colour-coded silicone sealant to finish the job.

If I ever had to do this I would be tempted to put in an LED replacement bulb, if you can get them in a similar light output, and do both at the same time. LED's should last indefinitely.

[cuneus]

OK thanks both of you for the replies

I read the bible which said "the light units are accessed from the underneath via the radiator intake to enable bulbs to be changed"

and was a bit confused

[Mr Tank]

Word of Warning!

Don't believe every thing in the bible.