Spoiler on a FHC

[Flyin Banana]

has anybody tried to fit a rear spoiler on a FHC, and would it look any good?

Cheers Rob

[db800]

If you check with schimg he has one from a 400 se fitted to his one and I am sure he will post photo's if asked nicely.
cheers db800

[hallsie]

I was planning to make one up so I could enter the BBWF SEAC look alike competition.

Cardboard and sticky tape though!

[grahamw48]

.

[Flyin Banana]

thats a little bigger than i was thinking, but thanks

[db800]

These are the only photo's I can find but contact schimg from his profile he will have better

another

[Flyin Banana]

thats more like it, thanks for the photo, i quite like the look if that, may have to keep an eye out for a spoiler for my FHC

Cheers Rob

[400SE Dave]

Not sure if this would work but the spolier on mine is a bit unusual as it is a cast taken of an SD1 Vitesse and then blended to fit.

The rake of a FHC looks similar to an SD1 so perhaps it could work??

Here are a couple of pics of mine from a couple of angles anyway:

Edited by 400SE Dave on Tuesday 1st February 16:37

[grahamw48]

That looks really neat !

[Wedg1e]

grahamw48 said:

That looks really neat !

Similar to the Zender but less prominent from the side.

[TVRleigh_BBWR]

400SE Dave said:

Not sure if this would work but the spolier on mine is a bit unusual as it is a cast taken of an SD1 Vitesse and then blended to fit.

Hi Dave, I'd be interested if you still have the cast and can make another.

also Pete Reeve has one on his FHC racer (not the best photo)

[Chassis 33]

...I've an SD1 Vitesse spoiler

Best bet is to look out for glass fibre ones on the bay, they're becoming more common than the rubber ones and most the work is done for you!

Regards
Iain