Discussion
MOT Testers' Manual said:
This inspection applies to all obligatory headlamps fitted.
Headlamps are not required to be fitted to vehicles used only during the hours of daylight, which are fitted with neither front nor rear position lamps, etc. (See 1.1.A).
Vehicles equipped with High Intensity Discharge (HID) or LED dipped beam headlamps may be fitted with headlamp washers and a suspension or headlamp self levelling system.
Where such systems are fitted, they must work; however, it is accepted that it may not be possible to readily determine the functioning of self levelling systems. In such cases, the benefit of the doubt must be given.
Headlamp washers may work in conjunction with the windscreen washers (when the dipped beam headlamps are switched on) or by a separate switch.
HID lamps may be identified by:
. taking a few seconds to reach full intensity
. having a bluish tinge to the light
. having an igniter module/inverter behind the headlamp
. having ‘DCR’ marked on the headlamp lens.
HID headlamps use high voltage and extra care should be taken when inspecting these items.
My underlining. Seems to be less than proscriptive to me.Headlamps are not required to be fitted to vehicles used only during the hours of daylight, which are fitted with neither front nor rear position lamps, etc. (See 1.1.A).
Vehicles equipped with High Intensity Discharge (HID) or LED dipped beam headlamps may be fitted with headlamp washers and a suspension or headlamp self levelling system.
Where such systems are fitted, they must work; however, it is accepted that it may not be possible to readily determine the functioning of self levelling systems. In such cases, the benefit of the doubt must be given.
Headlamp washers may work in conjunction with the windscreen washers (when the dipped beam headlamps are switched on) or by a separate switch.
HID lamps may be identified by:
. taking a few seconds to reach full intensity
. having a bluish tinge to the light
. having an igniter module/inverter behind the headlamp
. having ‘DCR’ marked on the headlamp lens.
HID headlamps use high voltage and extra care should be taken when inspecting these items.
MOT Manual
black1 said:
as from jan 1st this year if you have hid lights the car must have self levelling lights
and headlight washers or it will fail the mot
well unless your mates the tester lol
Ah. My Elise was tested 2 yrs ago. At the time there was lots of talk over legality and whether self levelling and washers were a requirement (my Elise had neither). and headlight washers or it will fail the mot
well unless your mates the tester lol
Tester was quite lenient on emissions as it happens

PaddyZulu said:
Andy, you have too much time on your hands up in that office. Like shooting fish in a barrel I believe.............. 

A long time since we had to prep a buggy for a little racing so it's great fun.

Gassing Station | Thames Valley & Surrey | Top of Page | What's New | My Stuff


