Re-wrapping a wiring loom?
Discussion
Re my previous post about changing the ignition resistor, I now need to re-wrap the foot-well loom on my Griff. The existing plastic wrap is not great, what are my alternatives? I've had cars before which had a cloth wrap, where do I get this? Needs to be flexible, removable (just in-case!) and preferably waterproof.
Any suggestions?

Any suggestions?

phillpot said:
clicky.... 
Hmmm, I looked at these, the cloth stuff looks ok but I've used it before and it can disintegrate, plus it was not that flexible once wrapped.
I had a VW and the wiring had a cloth covering that was more 'fluffy' in finish.
Edited by TVR Dummy on Wednesday 8th August 11:58
TVR Dummy said:
Russell Mc said:
I always use self amalgamating tape
I've considered this, problem is it can be a b
h to get off, I really want something I can remove easily if I need to get to any cables. Harrytsg said:
Ive used this for years, and found it no more difficult to remove than good quality insulation tape.
I use amalgamating tape for my aerial/Sat installs and it has to be cut off with blade sometimes, maybe a different type?I've seen this stuff which I might try, anyone used similar?
http://www.ebay.co.uk/itm/Coroplast-FuryAdhesive-T...
Vehicle Wiring Products have a VG selection: heat resistant, heat shrink, PVC sleeving, slit harness wrap, spiral binding, tape, twistwrap.
http://www.vehicle-wiring-products.eu/VWP-onlinest...
http://www.vehicle-wiring-products.eu/VWP-onlinest...
Gassing Station | General TVR Stuff & Gossip | Top of Page | What's New | My Stuff


