-ve camber

[chuggaboom]

Does anyone know the official factory standard figures for front camber on an S, Griff, Chimp, Cerb, Tuscan or T350 ?

I've done a search...came up with too many responses...most of which mentioned camber but didn't have any figures.

Thanks

G.

[HarryW]

Have look under the 'S' part guide on the TVRCC S-Wales site it gives figures for an S in the 'running gear settings' bit www.tvrcc-south-wales.co.uk/Sparts.asp#sets be advised there is a little note at the bottom contradicting the table. However I think you'll find those 'new' figures might have come from P.Humphries (greenV8S) so I'd tend to go with them or just wait a bit, I expect he will post something more meaningfull later

BTW had my geometry checked and had a requisit -1 deg front and -0.75 deg at the back (or near as damit)and am more than happy with the feel and handling of the V8S

Harry

[Nick Elliott]

There are some figures for the Tuscan on this thread:-

www.pistonheads.com/gassing/topic.asp?f=5&h=&t=57704

Nick

[GreenV8S]

Just out of curiosity, why do you want to know the settings for all those cars? Surely you don't own them all - that would be greedy!

>> Edited by GreenV8S on Thursday 9th October 13:27

[Pies]

If you get a copy of "Haynes data manual" it will give you lots of info for all "s" series all griff and chim(they differ for 4.0 and 5.0 models) and wedges and many other cars

Cost about £5 on ebay lot on there so dont buy an expensive copy

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=2436502872&category=14234

HTH

If you still want be to type out all the details drop me a line

>> Edited by Pies on Thursday 9th October 20:31

[chuggaboom]

GreenV8...u have mail.

[s27]

Have just put the Chimaera settings at www.tvrcc-south-wales.co.uk/chimaeraparts.asp#sets

There are also some Haynes Data sheets with other TVR models at www.tvrcc-south-wales.co.uk/password.asp

Password there but is probably known to members, requirement by Haynes for their use.

Cheers..SP

[Ballistic Banana]

Mine was recently done.

Front Camber.. LEFT initial - 1o 16' Final 1o 20'
RIGHT " 0o 23' Final 1o 29'

Specs were for front/rear min -1o 20' max -0o 40'

Rear Camber.. LEFT initial - 1o 59' Final -2o 06'
RIGHT initial - 1o 37' Final -1o 33'

Hope that helps

BB

ps does that 2o 06' look right for the left rear:sracthin: