Ignition switch- fitting?
Discussion
There are 2 grub screws in the body of the barrel that locate into lugs on the plastic part of the switch.
It is easy to get to the first screw but the second is difficult.
I managed to replace mine by undoing just one screw it took a bit of fiddling to get the new switch to locate but it did go in.
I found it easier to remove the lock barrel as you don’t have to worry about it lining up until after you have secured the switch unit.
Don’t forget that the lock barrel will only come out in one position (position 2 I think). I am not at home at the moment so I don’t have access to photos.
It is easy to get to the first screw but the second is difficult.
I managed to replace mine by undoing just one screw it took a bit of fiddling to get the new switch to locate but it did go in.
I found it easier to remove the lock barrel as you don’t have to worry about it lining up until after you have secured the switch unit.
Don’t forget that the lock barrel will only come out in one position (position 2 I think). I am not at home at the moment so I don’t have access to photos.
Gassing Station | General TVR Stuff & Gossip | Top of Page | What's New | My Stuff