This place is like heaven on earth
Discussion
caduceus said:
Definitely going to get some magic gel. my outside lights have shorted again ![frown](/inc/images/frown.gif)
Also thinking about relocating my battery to the boot, so will need cable and ends.
Good find Pen.
There was a video on youtube showing someone using a ball from a ball bearing and a vice to crimp battery cable eyelet terminals![frown](/inc/images/frown.gif)
Also thinking about relocating my battery to the boot, so will need cable and ends.
Good find Pen.
Will post it here if I find it
Anyway, a ball from a ball bearing could be taped onto the terminal, cable inserted into the terminal, placed in vice and ball squeezed into the terminal for crimping
PH member SturdyHSV https://www.pistonheads.com/gassing/topic.asp?h=0&... found out about the magic gel
Like yourself. I must order some for next time an underground mains cable joint trips its breaker
SPAL Radiator Fans https://www.a1electric.com/spal/faninfo.htm
![](https://thumbsnap.com/sc/U5dvxuZG.png)
![](https://thumbsnap.com/sc/U5dvxuZG.png)
Edited by Penelope Stopit on Sunday 13th June 10:52
Electric Turbo = Heaven
2 to 4 minutes boost, allow time for power pack recharge and boost again, easy to fit and wire
Proof of it working is in the YT videos
View Torqamp Video Channel https://www.youtube.com/c/TorqAmp/videos
![](https://thumbsnap.com/sc/TZLLxAgy.png)
These following videos are good fun, the first video shows the use of two electric turbos
2 to 4 minutes boost, allow time for power pack recharge and boost again, easy to fit and wire
Proof of it working is in the YT videos
View Torqamp Video Channel https://www.youtube.com/c/TorqAmp/videos
![](https://thumbsnap.com/sc/TZLLxAgy.png)
These following videos are good fun, the first video shows the use of two electric turbos
Have never crimped battery terminals, always use the screw type, I grab the cable with the screws and then use a blow torch to heat up and solder, fully filled with solder, takes practice though and the insulation does melt a little
These may be of some use to you https://www.12voltplanet.co.uk/battery-terminal-cl...
Cheers
![](https://thumbsnap.com/sc/g7LojNS6.png)
These may be of some use to you https://www.12voltplanet.co.uk/battery-terminal-cl...
Cheers
![](https://thumbsnap.com/sc/g7LojNS6.png)
PH Member DuncanM has found lots of ignition coils including ones for AJP8 Cerbera
NGK link
https://www.diycarserviceparts.co.uk/ngk-u2009-480...
![](https://thumbsnap.com/sc/Vv29b246.png)
https://www.gsparkplug.com/1x-ngk-ignition-coil-u2...
Lots here
https://www.diycarserviceparts.co.uk/electrical-li...
NGK link
https://www.diycarserviceparts.co.uk/ngk-u2009-480...
![](https://thumbsnap.com/sc/Vv29b246.png)
https://www.gsparkplug.com/1x-ngk-ignition-coil-u2...
Lots here
https://www.diycarserviceparts.co.uk/electrical-li...
Gassing Station | General TVR Stuff & Gossip | Top of Page | What's New | My Stuff