Wot servo have I got

[evolutionvalet]

I have an unfinished project. It is a Mk1 Zephyr Zodiac and has been fitted with a small 7 inch servo with master cylinder under the dash at some time in its past.
Now I want to replace or rebuild the servo as its sat for years unfortunately, I am not sure what car its from. Someone has mentioned Mark 1 Fiesta.
Now the master cylinder carries the markings GIRLING 2 74660186

The servo itself is a 7 inch diameter servo with the numbers 20MS9288 on the pushrod side and on the cylinder side has two lines of numbers. The top line has been worn away but the bottom reads 74049308.

The main problem is that the underdash mountings have been fabricated to accept this servo and there isnt much room under there without starting to cut away a lot of metal. So if anyone can help and has a Lucas/Girling catalogue that lists the master cylinder that would be great.

Cheers

Kev

[tempus]

Hi,you would appear to have a supervac unit,if it has a 1"non return valve hole it came off a fiesta,van,xr2,from between 78-83,hope that helps, Tempus

[evolutionvalet]

Many thanks. Any chance youn know where to get one. motor factors around here havent been too helpful....

K

[tempus]

Hello,sorry for the delay, past parts in bury st edmunds will have one,but i do not know your local factors.If you want to look at a picture of one and make sure it is correct look up www.brakeparts.co.uk and look on their online cat.you can enlarge the pic. by clicking on it,hope that helps Tempus

[evolutionvalet]

Many thanks for the help.

I am not too far from Bury St Edmunds so might take the servo there and see what they can do.

Cheers

Kev