Discussion
kriss5154 said:
Have 96 Chimera always used Autoglam polish is passed had some spray work done it’s not polishing up well anybody got any ideas pulling my hair out ??
Can you post pictures and explain a bit more? Doing any polishing by hand is always going to have limited results, you may well need a machine polisher or someone with one to 'cut' the clear coat a little more. Again, pictures will help I'm sure
I would ask the question on detailing world.
I’m assuming you’re using super resin polish? As far as I’m aware that product contains no abrasives so you’d need something like a swirl remover to cut the clear coat back a little.
T cut would do it but it’s quite aggressive. There are some milder cutting polishes available, although if you’re doing it by hand t cut will be ok if you take it easy.
Incidentally, if you don’t already, you should give it a top coat after you’ve used super resin polish. Something like autoglym extra gloss protection or a wax would do the job.
I’m assuming you’re using super resin polish? As far as I’m aware that product contains no abrasives so you’d need something like a swirl remover to cut the clear coat back a little.
T cut would do it but it’s quite aggressive. There are some milder cutting polishes available, although if you’re doing it by hand t cut will be ok if you take it easy.
Incidentally, if you don’t already, you should give it a top coat after you’ve used super resin polish. Something like autoglym extra gloss protection or a wax would do the job.
Gassing Station | Bodywork & Detailing | Top of Page | What's New | My Stuff