What prep before topping up Exo coating

[Loose_Cannon]

Earlier this year I did a DIY treatment with G Techniq Crystal Serum Light and a V3 Exo top coating. I've been very pleased with the results but feel its about time to top up the V3 as recommended by so many people.

Does this require any prep over and above a good wash? Would panel wipe or a light polish wipe out the CSL underneath and send it back to scratch?

[Summit_Detailing]

Wash as normal, some fallout remover, rinse, dry & top-up with C2v3.

cheers

Chris

[Loose_Cannon]

Thanks, I've only ever used that kind of thing on wheels but if it wont hurt the CSL I'll give it a go.

[Summit_Detailing]

Loose_Cannon said:

Thanks, I've only ever used that kind of thing on wheels but if it wont hurt the CSL I'll give it a go.

It'll be absolutely fine, leave it on for 5-10mins to do its thing - good time to put the kettle on!

cheers

Chris

[sixspeed]

Summit_Detailing said:

Wash as normal, some fallout remover, rinse, dry & top-up with C2v3.

cheers

Chris

C2v3 isn't the same as EXOv3 that was mentioned in the OP?