Mercedes R107 hard top installation
Discussion
Evening all,
Wife bought an R107 at the start of the year. Came with the hard top installed, which was fairly straight forward to take off but I will be damned if I can work out how to get it back on!!
I have been watching the below video: -
https://www.youtube.com/watch?v=9W3GMoPWUqM
It's kind of helped but it doesn't show a few things. My questions: -
1. Is the order I should be doing things in lever, front and then sides?
2. What position should the leaver be in before the roof gets put on?
3. With the side screws do they need to be in a certain position before the roof goes on as I can't get them to move at all, this is the main problem.
4. The front is definitely on and I think the back is also. Should the back sit totally flush or is there space for finger tips underneath?
Thanks for the help. It would be embarrassing if I have to take it to a garage to get them to do it!
Wife bought an R107 at the start of the year. Came with the hard top installed, which was fairly straight forward to take off but I will be damned if I can work out how to get it back on!!
I have been watching the below video: -
https://www.youtube.com/watch?v=9W3GMoPWUqM
It's kind of helped but it doesn't show a few things. My questions: -
1. Is the order I should be doing things in lever, front and then sides?
2. What position should the leaver be in before the roof gets put on?
3. With the side screws do they need to be in a certain position before the roof goes on as I can't get them to move at all, this is the main problem.
4. The front is definitely on and I think the back is also. Should the back sit totally flush or is there space for finger tips underneath?
Thanks for the help. It would be embarrassing if I have to take it to a garage to get them to do it!
I do mine front, sides rear, lever should be in mid position (release the soft top cover, let the lever return, pop the cover back closed if that makes sense. The side ones on mine are a bit of an arse, make sure they're properly aligned and they take a full half turn to lock them down. Then clamp with the lever. Yes, there's a wee gap round the hardtop(it's sitting on a seal a bit inside the outer edge, if it touched it'd mark the paint)
Before doing any of that though, make DAMN sure the lever cable clip under the soft top cover is properly in place. If it comes off it wont allow the safety catch to release, you need to get under the soft top cover to put it back on, but you need to get the hardtop off to get to the bit that's stopping you getting the hardtop off if you get my drift. You will find making new swearwords becomes very inventive and there's a good chance(I did) that you will scratch the paint prodding around to release the catch. It's not uncommon either.
Before doing any of that though, make DAMN sure the lever cable clip under the soft top cover is properly in place. If it comes off it wont allow the safety catch to release, you need to get under the soft top cover to put it back on, but you need to get the hardtop off to get to the bit that's stopping you getting the hardtop off if you get my drift. You will find making new swearwords becomes very inventive and there's a good chance(I did) that you will scratch the paint prodding around to release the catch. It's not uncommon either.
Don't forget to set the small lever (centre lock)
This is a pretty good guide
http://www.benzworld.org/forums/r-c107-sl-slc-clas...
This is a pretty good guide
http://www.benzworld.org/forums/r-c107-sl-slc-clas...
Gassing Station | Classic Cars and Yesterday's Heroes | Top of Page | What's New | My Stuff


