Injectors for triumph 2.5pi efi conversion
Discussion
Hi
I am currently working on a efi conversion for my 1973 triumph 2.5pi and need to get some injectors. I was wondering if anyone on here would know if the injectors in the link below would be suitable for my project? (I can get them at a much lower price). I know they will have enough flow. But I I'm not sure about if the extended nose is an issue.
https://www.efihardware.com/products/2720/Bosch-In...
Just a little extra info on my project to give people a background so they can make recommendations.
To hold the electronic injectors, i am going to use the original Lucas pi throttle bodies drill the existing injector holes out to the 13.5/14mm and strip the butterflies and block off any holes. Having a single throttle body on the end of the plenium tank. The throttle body I have is an 80mm one I got off eBay but from previous reading it may be. A bit large to get reliable performance down low. If it doesn't work well I will replace it. The ecu I am going to use will be an exumatsers emu classic with full sequential fuel injection. And either use a msd 6al2+stripped distributor for the spark being controlled from the ecu. Or also fully sequential spark.
Once the efi has been completed I have a Eaton m62 super charger that I will fit to the engine with forged pistons and a couple new pullies to convert to a 6 rib serpentine belt. I also have a. Lower compression head from a 2500tc that I was considering using.
Thanks for any help people around here can provide.
I am currently working on a efi conversion for my 1973 triumph 2.5pi and need to get some injectors. I was wondering if anyone on here would know if the injectors in the link below would be suitable for my project? (I can get them at a much lower price). I know they will have enough flow. But I I'm not sure about if the extended nose is an issue.
https://www.efihardware.com/products/2720/Bosch-In...
Just a little extra info on my project to give people a background so they can make recommendations.
To hold the electronic injectors, i am going to use the original Lucas pi throttle bodies drill the existing injector holes out to the 13.5/14mm and strip the butterflies and block off any holes. Having a single throttle body on the end of the plenium tank. The throttle body I have is an 80mm one I got off eBay but from previous reading it may be. A bit large to get reliable performance down low. If it doesn't work well I will replace it. The ecu I am going to use will be an exumatsers emu classic with full sequential fuel injection. And either use a msd 6al2+stripped distributor for the spark being controlled from the ecu. Or also fully sequential spark.
Once the efi has been completed I have a Eaton m62 super charger that I will fit to the engine with forged pistons and a couple new pullies to convert to a 6 rib serpentine belt. I also have a. Lower compression head from a 2500tc that I was considering using.
Thanks for any help people around here can provide.
Gassing Station | Classic Cars and Yesterday's Heroes | Top of Page | What's New | My Stuff