Coloured Glass DIY
Author
Discussion

Aprisa

Original Poster:

1,898 posts

289 months

Monday 13th March 2006
quotequote all
We were in John Lewis's at the weekend and noticed they are selling coloured glass Kitchen Worktops and Splash backs. The worktops looked like they would scratch easily and indeed already showed signs of damage, but the splash backs looked ideal for going behind the Rayburn we have just installed.

The prices quoted were astounding and worked out at about £1200 for a small section when Jigged!!!

Question is:- if I were to get a piece of toughened glass polished edges and drilled for wall mounting, would it look as good if I sprayed Acrylic paint on the back (two or three coats) and then hung it up?

Am I missing something blatantly obvious?

Cheers
Nick

bga

8,134 posts

282 months

Monday 13th March 2006
quotequote all
I did that last year to frosted glass inserts in a wardrobe. It looks a bit of a dogs dinner from the sprayed side but looks even on the side that is meant to be viewed. Worth practicing with a small but first to make sure the effect will be OK when against the wall.

Parrot of Doom

23,075 posts

265 months

Monday 13th March 2006
quotequote all
Coloured glass only looks good when its backlit by light. Think about a stained glass window - you can't see them at night.

Fitting one against a wall, unless theres natural light coming from behind it, it'll look poop.

pdV6

16,442 posts

292 months

Monday 13th March 2006
quotequote all
Parrot of Doom said:
Coloured glass only looks good when its backlit by light.

...as opposed to?

sleep envy

62,260 posts

280 months

Monday 13th March 2006
quotequote all
Aprisa said:
Question is:- if I were to get a piece of toughened glass polished edges and drilled for wall mounting, would it look as good if I sprayed Acrylic paint on the back (two or three coats) and then hung it up?


No need to spray as you can get coloured manifestation/film and apply it to the back of the glass before mounting.

ETA best effect is to paint the wall white and it needs to be plastered to a good level i.e. be absolutely smooth and flat so lots of rubbing down needed.

>> Edited by sleep envy on Monday 13th March 12:51

cinque

833 posts

313 months

Monday 13th March 2006
quotequote all
Looks good as splashbacks/upstands but you need spot-lights to give it a good effect. (i.e. undercupboard low-voltage)

It is a lot of hassle to size up and fit (all plug sockets and edges need cutting out before colouring and toughening the glass) if it comes back even mm out you're shafted. (Firms that supply and fit use hardboard to make up the templates).

Its adhered to the wall using a silicon type compound, but you have to be careful about which one to use, cause if the colouring hasnt been done properly on the glass, it shows through and looks pants! (especially when the spots shine on it).

Also, if you have any movement 'at all' from the wall (i.e. new plaster, heating pipes running behind) forget it, because the glass cannot take it and you'll end up with it either a) falling off the wall/coming loose or b) splitting.


It does look stunning in the right places & installed properly, but dont try and scrimp, you will regret it in the long run.