Very Odd.......any explanations ??
Discussion
There I was, sitting at my kitchen table browsing the interweb...
I had taken off a large brushed steel finger-ring about an hour ago and placed it alongside another ring on the surface of the table. About ten minutes ago I pushed them both out of the way to reposition my mouse mat.The larger ring stayed still (as if glued to the surface) so I pushed it away and it struggled off (as if held by a magnet). As I touched it I felt it was very warm, the other ring however was very cold (as metal tends to be).
I felt the table around where the ring was sat - this too was warm to the touch.....
Why would this happen ?
The warmth was very isolated to the ring and the table where it was sat - everything else was cold......

move slowly away from the table and reach behind you in the drawer fro the meat cleaver
(egg whick might do)
then beat....
tskkkk spelling again, I'll just sort it
then beat......yourself severely and stop thinking about Derek acorah so much
>> Edited by rich 36 on Saturday 18th March 20:40
(egg whick might do)
then beat....
tskkkk spelling again, I'll just sort it
then beat......yourself severely and stop thinking about Derek acorah so much
>> Edited by rich 36 on Saturday 18th March 20:40
gopher said:
Was the one ring in the area of the fan vent on your laptop and so got hot and melted the varnish on your table and so became glued?
Cheers
Paul
This is a very good call....
But the fan vent is on the other side....and there is about 8inches gap between the nearest (cold) side of the laptop and the warm place....

Gorvid said:Maybe similar - transformer in laptop or outside on adaptor? Other coils inside? If there are inductively wound coils inside then your ring may be heating up due to mag field near coils and melting varnish to get stuck. Transformer itself may stay cool due to positioning and fan taking hot air from this and processor out (the other side) while ring heats up.
gopher said:
Was the one ring in the area of the fan vent on your laptop and so got hot and melted the varnish on your table and so became glued?
Cheers
Paul
This is a very good call....
But the fan vent is on the other side....and there is about 8inches gap between the nearest (cold) side of the laptop and the warm place....
Don't know about laptop internals so guessing away here

The two rings were more or less touching and placed about 8inches to the left of the laptop.
The battery is about 3 feet below the table - but is right below the area....
The power cable passes within a couple of inches of the rings. The varnish is very old/solid BUT there is a bit of a subtle patch of something in that area...maybe a spillage from the other day
The battery is about 3 feet below the table - but is right below the area....
The power cable passes within a couple of inches of the rings. The varnish is very old/solid BUT there is a bit of a subtle patch of something in that area...maybe a spillage from the other day

Wireless broadband connection?
That would be the electro magnetic dooberry that was on the same frequency as the thingumajig that caused an induction loop and warmed the ring, melting the varnish etc etc.
I hate to think how it works, but the PCM card does the same to pens and things I have near my laptop. Now ... see how far away you can place your major internal organs while still typing.

That would be the electro magnetic dooberry that was on the same frequency as the thingumajig that caused an induction loop and warmed the ring, melting the varnish etc etc.
I hate to think how it works, but the PCM card does the same to pens and things I have near my laptop. Now ... see how far away you can place your major internal organs while still typing.

Gassing Station | The Pie & Piston Archive | Top of Page | What's New | My Stuff






