Dull decorating question.....
Discussion
NDA said:
Thanks.....
Is there any value in matching up (or not) the previous joins/seams?
If the paper isn't perfectly flush, then I would take it off, as you will get lines, and it will be difficult to match up the lines exactly. Plus if you do match up the lines, this is where it is most likely to start lifting, and it will be harder to sort out the paper lifting underneath, best to overlap if possible.Is there any value in matching up (or not) the previous joins/seams?
Edited by BlueEyedBoy on Monday 29th September 16:55
Personally, I never done it - stripped and repaired the wall. The advantage of this is it allows you to find the problems with the plaster underneath. The disadvantage is it allows you to find the problems with the plaster underneath...
I am assuming it isn't vinyl (in which case, pealing it of is simple and it leaves a sort of lining paper).
I would think that a some form of cleaning and degreasing (sugar soap) would help adhesion but you should be careful not to soak it (and allow it to dry). That might give you an idea if the paper will bubble when it gets damp (when the new glue goes on top).
I am assuming it isn't vinyl (in which case, pealing it of is simple and it leaves a sort of lining paper).
I would think that a some form of cleaning and degreasing (sugar soap) would help adhesion but you should be careful not to soak it (and allow it to dry). That might give you an idea if the paper will bubble when it gets damp (when the new glue goes on top).
Gassing Station | The Pie & Piston Archive | Top of Page | What's New | My Stuff



