Exhaust Removal question
Discussion
so i'm now the proud owner of a shiny new Larini Club Sport exhaust which is currently living in my Living Room (not ideal - also does'nt sound too good either
). The reason its in the lounge rather than on the car is the damn factory model just wont budge. I know that many of you have replaced your's - can anyone offer any advice on how to remove the bolts that are simply gunked on the existing exhaust. (if not - i might just have to take a dremmil to it at the weekend). I've tried the normal tricks - tightening before loosening, smothering with wd40 etc - all with no luck. of course the other option would be to remove and replace the CAT - but would rather not do this.
HELP Please!!!
). The reason its in the lounge rather than on the car is the damn factory model just wont budge. I know that many of you have replaced your's - can anyone offer any advice on how to remove the bolts that are simply gunked on the existing exhaust. (if not - i might just have to take a dremmil to it at the weekend). I've tried the normal tricks - tightening before loosening, smothering with wd40 etc - all with no luck. of course the other option would be to remove and replace the CAT - but would rather not do this. HELP Please!!!
Of the 3 bolts connecting the cat to the exhaust when I took mine off; 1 came off easily, the other rounded off, the other just would not move.
Get a hacksaw to it is the only way! Just make sure you purchase the Eliseparts exhaust fitting kit so you have new bolts and gaskets.
It's a pain but not impossible - just takes a bit of time.
Good luck!
(PS: you've done all the right stuff so far - now it's time to get angry
)
T
Get a hacksaw to it is the only way! Just make sure you purchase the Eliseparts exhaust fitting kit so you have new bolts and gaskets.
It's a pain but not impossible - just takes a bit of time.
Good luck!
(PS: you've done all the right stuff so far - now it's time to get angry
) T
Thanks - i've taken a hacksaw to one of them already - just struggling for room for the other two. BTW - i assume the exhaust and CAT mounting plate are not threaded. (i already have the fitting kit - i have the same problem as you - click-buy/ click-buy - spent a small fortune with EliseParts recently!!)
I'm trying to remember and can't (it was a year ago we did it).
Definitely the exhaust itself has no studs on it but I can't remember whether the cat has threads or you just simply use bolts through the middle. Sorry that's not much help - hopefully someone else can answer that one
T
Definitely the exhaust itself has no studs on it but I can't remember whether the cat has threads or you just simply use bolts through the middle. Sorry that's not much help - hopefully someone else can answer that one
T
did mine a week ago not much left of the exhaust side 1's (so rusty could not decide what size spanner they were)so after 24 hours of libberal wd40ing and a lot of grunting i got the manifold side undone took all the mountings off and with a bit of perswation she came out with the cat. then ground off the bolts and drilled out the studs in the cat(could not get them to come out) and reassembled cat to zorst i left the original studs in the manifold side of the cat and just used s/snuts (eliseparts fitting kit) and lots of coppeer greese. went back togeather a treat all in took about 2 hours and well worth it sounds great.
Gassing Station | Elise/Exige/Europa/340R | Top of Page | What's New | My Stuff


