Window Leather & Manuals
Window Leather & Manuals
Author
Discussion

Tulso

Original Poster:

17 posts

247 months

Monday 31st July 2006
quotequote all
I've got my 02 Elise 111S home.

Couple of Queries,

I Got a Workshop Manual from Ebay on CD - not a particularly good scan and not much detail on the engine. Only a fiver, so no great loss.
Haynes will have Rover manuals for cars which share the K-Series engine- but which one - any ideas? - it's the 156BHP variant.


The driver side window sticks sometimes - has anyone else found the same problem and is there a fix or work-around?

The leather on the driver seat is scraped. A local upholsterer reckons it can be fixed by stitching a velcro strip at the rear of the flat area, also at the front under the curve, then making up a patch to suit. The original scraped leather remains in place. Any opinions?


Ta in advance.
Iain

Janitor

2,372 posts

250 months

Monday 31st July 2006
quotequote all
I'd just take a look into the door for the winder... remove door card and check the mechanism for stray bits / potential obstructions and lubricate / grease any moving parts

As for the leather repair..? Again, I'm no expert but I'd say that was to a difficult issue to sort to a high standard without major re-upholstery. A patch may well improve things, but isn't going to be too great

S works

10,166 posts

281 months

Monday 31st July 2006
quotequote all
Re: Window - if it's sticky get some silicon spray from Halfords (yellow can), and give the window runners a good lube (peel back the rubber strip along the top of the door to get the little red spary extension down in there). There are 2 guides, one along the front edge of the window, one along the rear. The rubber can get hard and create a lot of friction on the window - a good spraying and winding the window up and down a bit soon sorts it.

Re: Seat leather - to retrim a full seat at the trim shop is about £250 IIRC, better to get it done properly than to bodge a repair.

chopperver1

19 posts

253 months

Monday 31st July 2006
quotequote all
When you have the door panel off check the condition of the rubber in the guides. Mine was completely shot on the rear guides and was bunching up under the glass as it was wound down. So winding was overly hard and the window would not go down fully.

Rubber/Velour insert is a cheap part from dealer to buy but a bu**er to fit. Window out job and lots of sharp edges.

If an oil/solvent based lubricant (eg WD40) has been used on the guides in the past then the rubbers can swell and pinch the glass. This will eventually lead to the guide tearing. As the last post stated, only use a silicon spray to lube the guides.

The winder mechanism is fragile. If you keep forcing it then you'll bend the scissor mechanism or the glue bonding the glass to the mechanism will fail.


Tulso

Original Poster:

17 posts

247 months

Monday 31st July 2006
quotequote all
Ta for the advice. That'll be my next Rainy Day job.

Iain