Another polishing question: what did I do wrong here?
Discussion
I thought I'd give the Elise its once monthly wash and wax.
I hosed the car, then used Autoglym Shampoo. Rinsed. Dried.
It was then that I found the polish ( Autoglym Super Resin ) didn't really want to know. It seemed to leave the paintwork flat, certainly not an improvement on the shampoo. So I gave up after doing the front clam.
The car looks fine, just that there are still pockets of marks, a bit like after getting caught in rain.
I noticed quite a lot of rusty brown crap ( dirt! ) was coming off into the polishing cloth.( car is green! )
My theory: I did not use enough shampoo to water, ie the suds were flat.
The car was last valeted by Sinclaires, which makes me think they use a top quality industrial wash and wax, so hence the need for a real soapy and suddy shampoo.
I need to remove all dirt and old wax etc, before polishing, and I did not do that?
Am I on the right track??
All advice appreciated! ( For example, if there is a better washing solution than Autglym Shampoo. I was also wondering if I should clay the car?? )
I hosed the car, then used Autoglym Shampoo. Rinsed. Dried.
It was then that I found the polish ( Autoglym Super Resin ) didn't really want to know. It seemed to leave the paintwork flat, certainly not an improvement on the shampoo. So I gave up after doing the front clam.
The car looks fine, just that there are still pockets of marks, a bit like after getting caught in rain.
I noticed quite a lot of rusty brown crap ( dirt! ) was coming off into the polishing cloth.( car is green! )
My theory: I did not use enough shampoo to water, ie the suds were flat.
The car was last valeted by Sinclaires, which makes me think they use a top quality industrial wash and wax, so hence the need for a real soapy and suddy shampoo.
I need to remove all dirt and old wax etc, before polishing, and I did not do that?
Am I on the right track??
All advice appreciated! ( For example, if there is a better washing solution than Autglym Shampoo. I was also wondering if I should clay the car?? )
jondude,
If you feel the paintwork does it feel rough a bit like fine sandpaper? If so then I would Clay the car after washing.
The car wash shampoo shouldnt effect the wax that the last valeters applied and should just leave the paintwork looking clean.
Did they apply any kind of sealant to the paintwork or was it just wax?
Kev
If you feel the paintwork does it feel rough a bit like fine sandpaper? If so then I would Clay the car after washing.
The car wash shampoo shouldnt effect the wax that the last valeters applied and should just leave the paintwork looking clean.
Did they apply any kind of sealant to the paintwork or was it just wax?
Kev
Thanks for the quick replies.
Not sure about any sealant. I wouldn't think so somehow, as the valeting they do is a free service, so I don't think they go too mad with things.
I did notice the water I was using seemed flat - not many suds. I wonder too, if I made a mistake by using warmish water??
It is not bad as such, just not the usual shiny finish. Bit like a half done job.
Not sure about any sealant. I wouldn't think so somehow, as the valeting they do is a free service, so I don't think they go too mad with things.
I did notice the water I was using seemed flat - not many suds. I wonder too, if I made a mistake by using warmish water??
It is not bad as such, just not the usual shiny finish. Bit like a half done job.
Ok where do we start. First off all throw away all the Autoglym.
Swissoil
Poorboys
ZYMOL
are all great. As a rule of thumb, bad waxes have a fine talk like powder in order to make them show up on paintwork. This makes the wax crap.
Only use products from one manufacturer - most products are not complimentary especially if you use autoglum - it is quite aggressive to natural products.
Run you through my method - I am not as anal as some but more than others. Twice a year or a new car needs this through job.
Wash the car properly. Start with the wheels and arches. When clean and rinsed the the rest of the bodywork. Rinse / wet the car down with water then use the 2 bucket method to clean the car. It is best to do this twice and make sure you get all the muck off the little corners. Dry using zymol synthetic chamois
It is very important you get all the dirt off because it is an abrasive. Next klay bar your car. This removes oxidation/ tars and ingrained crap and "levels" the paint. Then wash. Next use the Zymol "chocolate" HD Clense. It is like a wax but it further levels the paint. You will find that the paint feels like the finest satin.
Finally the wax. I use Zymol Ital for the bodywork. It is made for plastic cars and is quite flexible. I use Zymol Atlantique in the high "finish" areas where I really want the light to catch, along the front and rear wings and across the front of the front clam.
Then wax the wheels with Zymol Titanium because it is very tough. When done then further seal with Zymol wheel sealant.
For the trim use Zymol Vinyl conditioner and the tyres need Zymol Tyre preserve.
The only deviation from zymol is the windows are treated with rainex. This product is superb at dispersing everything from rain to bugs.
I also use the autoglym metal polish to clean the undertrays. I have loads left over from when I thought Autoglum was the dogs danglies (poor deluded me).
Swissoil
Poorboys
ZYMOL
are all great. As a rule of thumb, bad waxes have a fine talk like powder in order to make them show up on paintwork. This makes the wax crap.
Only use products from one manufacturer - most products are not complimentary especially if you use autoglum - it is quite aggressive to natural products.
Run you through my method - I am not as anal as some but more than others. Twice a year or a new car needs this through job.
Wash the car properly. Start with the wheels and arches. When clean and rinsed the the rest of the bodywork. Rinse / wet the car down with water then use the 2 bucket method to clean the car. It is best to do this twice and make sure you get all the muck off the little corners. Dry using zymol synthetic chamois
It is very important you get all the dirt off because it is an abrasive. Next klay bar your car. This removes oxidation/ tars and ingrained crap and "levels" the paint. Then wash. Next use the Zymol "chocolate" HD Clense. It is like a wax but it further levels the paint. You will find that the paint feels like the finest satin.
Finally the wax. I use Zymol Ital for the bodywork. It is made for plastic cars and is quite flexible. I use Zymol Atlantique in the high "finish" areas where I really want the light to catch, along the front and rear wings and across the front of the front clam.
Then wax the wheels with Zymol Titanium because it is very tough. When done then further seal with Zymol wheel sealant.
For the trim use Zymol Vinyl conditioner and the tyres need Zymol Tyre preserve.
The only deviation from zymol is the windows are treated with rainex. This product is superb at dispersing everything from rain to bugs.
I also use the autoglym metal polish to clean the undertrays. I have loads left over from when I thought Autoglum was the dogs danglies (poor deluded me).
Hi
You could see the thread ive done on detailing.
You may have done already.
Pleople seem to have mixed views.
www.pistonheads.com/gassing/topic.asp?t=292608&f=15&h=0
Hope it helps
Dave
You could see the thread ive done on detailing.
You may have done already.
Pleople seem to have mixed views.
www.pistonheads.com/gassing/topic.asp?t=292608&f=15&h=0
Hope it helps
Dave
dave_s2_111s said:
Hi
You could see the thread ive done on detailing.
You may have done already.
Pleople seem to have mixed views.
www.pistonheads.com/gassing/topic.asp?t=292608&f=15&h=0
Hope it helps
Dave
You could see the thread ive done on detailing.
You may have done already.
Pleople seem to have mixed views.
www.pistonheads.com/gassing/topic.asp?t=292608&f=15&h=0
Hope it helps
Dave
No mixed views - that polish job is incredible.
Gassing Station | Elise/Exige/Europa/340R | Top of Page | What's New | My Stuff




