heater controls
Author
Discussion

carlymart

Original Poster:

618 posts

245 months

Monday 14th August 2006
quotequote all
the hot cold control in my s2 does not rotate all the way round from hot to cold
should it?????


thanks in advance

TonyHetherington

32,091 posts

281 months

Monday 14th August 2006
quotequote all
If it were a clock face it should go from about 7 o'clock (cold) round to 5o'clock (hot).

abz 7001

383 posts

283 months

Monday 14th August 2006
quotequote all
Worstcase scenario is your heater matrix unit is seized, common problem as the unit is not sealed and the control is linked via cable to the unit. Exposed to moisture etc they have been known to seize. You can get to it with the insepction covers off and get some wd40 on the cable. If you are lucky this frees it up, if you are not the unit needs replacing which is a front calm off job. IIRC its about 600pounds to replace I think. Someone who has experienced it and had it fixed will tell you shortly (and in more helpful detail). I was lucky and the WD40 freed mine up (2002 S2)
Hope that helps - Stuart

TonyHetherington

32,091 posts

281 months

Monday 14th August 2006
quotequote all
Abz....completely similar question (sorry for the thread hijack) but my unit has recently just completely stopped - nothing on 1/2/3. Then it started again. Then it stopped.

When yours seized did it just do that or was it struggling? I've taken the inspection panels off and can't see a thing. What bit did you actually spray?!

Thanks

carlymart

Original Poster:

618 posts

245 months

Monday 14th August 2006
quotequote all
abz 7001 said:
Worstcase scenario is your heater matrix unit is seized, common problem as the unit is not sealed and the control is linked via cable to the unit. Exposed to moisture etc they have been known to seize. You can get to it with the insepction covers off and get some wd40 on the cable. If you are lucky this frees it up, if you are not the unit needs replacing which is a front calm off job. IIRC its about 600pounds to replace I think. Someone who has experienced it and had it fixed will tell you shortly (and in more helpful detail). I was lucky and the WD40 freed mine up (2002 S2)
Hope that helps - Stuart
sound like the problem it does move just not all the way round will try the wd 40 thanks

abz 7001

383 posts

283 months

Monday 14th August 2006
quotequote all
TonyHetherington said:
Abz....completely similar question (sorry for the thread hijack) but my unit has recently just completely stopped - nothing on 1/2/3. Then it started again. Then it stopped.

When yours seized did it just do that or was it struggling? I've taken the inspection panels off and can't see a thing. What bit did you actually spray?!

Thanks


Nothing on 1-2-3 sounds like a fuse or relay? To clarify mine is seized again, am fearing its terminal this time. However the fan is unaffected, all 3 speeds work its just the temperature control knob that has huge amounts of resistance and only turns through about 30 degrees in either direction now.

Going by memory stand on the passenger side of the car with both panesl and vents off, the unit in quesion on my boggo 120bhp S2 sits forward of the cooling fins slightly onto the driver side, big black box. It had a lever coming off it that rotated 180 degrees (between hot and cold I imagine) attahced to which was the cable that runs back to the dash, covered it all in wd40 whilst a mate waggled the nob and we got it free. Dont think I hav etouched it since and just found its knackered again! Doh

Hope you followed that. Hardest part was getting your hand with can anywhere near it, I resorted to allowing a massive cloud in the general direction and then corssing my fingers and toes!

Am sure there will is an easier to follow guide somewhere otherwise I have no idea how I came to be doing this. Will check my favourites and get back to you. Hope this helps in the meantime.

Stuart

nightmare

5,279 posts

315 months

Monday 14th August 2006
quotequote all
TonyHetherington said:
Abz....completely similar question (sorry for the thread hijack) but my unit has recently just completely stopped - nothing on 1/2/3. Then it started again. Then it stopped.

When yours seized did it just do that or was it struggling? I've taken the inspection panels off and can't see a thing. What bit did you actually spray?!

Thanks

do you have an early S2 Tony? My heaters pretty much had it now....it'll still do hot (ish) and cold (ish) if you can get it to actually turn..though that in itself is nearly impossible. however the fan now doesn't work on 1, only 2 and 3; and it's all going wrong from discussions with Lotus technical bod (who wont be named!) the early ones were just utter cack and would never have more than a few year life expectancy...

Oh, and all my vents are now just pouring dust out if I open them - think some form of filter must have died (though rather suspicious timing coinciding with last service....wonder if there's a plate or similar you could forget to put back on...anyone?)

TonyHetherington

32,091 posts

281 months

Monday 14th August 2006
quotequote all
I have a model year '04 car with air con but I think the actual heater unit itself is the same, it's simply that I have the cooler box too.

I checked all the switches (which all have power going to and from them) and all the fuses and they're all absolutely fine - so it is something downstream of the switches.

So it doesn't seem like something mechanical like it jamming, but rather electrical or a loose connection.

I do have a warranty but I just need to actually get the car there (which isn't easy) as it's a fair way away.

Many thanks for the info guys
Tony

abz 7001

383 posts

283 months

Monday 14th August 2006
quotequote all
nightmare said:
TonyHetherington said:
Abz....completely similar question (sorry for the thread hijack) but my unit has recently just completely stopped - nothing on 1/2/3. Then it started again. Then it stopped.

When yours seized did it just do that or was it struggling? I've taken the inspection panels off and can't see a thing. What bit did you actually spray?!

Thanks

do you have an early S2 Tony? My heaters pretty much had it now....it'll still do hot (ish) and cold (ish) if you can get it to actually turn..though that in itself is nearly impossible. however the fan now doesn't work on 1, only 2 and 3; and it's all going wrong from discussions with Lotus technical bod (who wont be named!) the early ones were just utter cack and would never have more than a few year life expectancy...

Oh, and all my vents are now just pouring dust out if I open them - think some form of filter must have died (though rather suspicious timing coinciding with last service....wonder if there's a plate or similar you could forget to put back on...anyone?)


Mine is an early 2002 S2 also - sounds identical excpet for the fan symptoms! Wonder what the weight saving is to just remove it! Regarding the dust if you can find the vent inlets ladies stockings are very effective!
Stuart

heesen

97 posts

243 months

Monday 14th August 2006
quotequote all
Same things happened to mine. Checked flap on heater matrix, will go from cold to half way and then stop. Brute force will not get it to go any further. As it moves half way doesnt sound like its siezed - Not sure what the problem is.
If you sort yours out let me know the solution.

andy_s

19,857 posts

290 months

Monday 14th August 2006
quotequote all
This all sounds horribly familiar - I had the same problem and am now waiting for another reason to take off the clam to fix a heater. I have several warm jackets ready for winter and will take a flask of tea everywhere I go.

www.pistonheads.com/gassing/topic.asp?t=165108&f=15&h=0

TonyHetherington

32,091 posts

281 months

Monday 14th August 2006
quotequote all
Andy - great link, thank you - my control of top vs bottom sticks and it could well be that. Service panel off tonight me thinks