Mintex 1144 Screechy Brakes
Discussion
I have just upgraded my front brakes to Mintex 1144, and also had new drilled & grooved discs. on my lotus elise S1. The problem is the pads are really really sreeching on soft braking! Had a new pair sent as a replacement and although not bedded in yet, the sreeching has already started to creep in!
The pads have the baffle pads on the backs and copper ease plastered all over them so i was hoping this would stop this. BUT NO!
Has anyone had problems with these type, as i was told they would not screech, and at present i sould like a bloody black cab!!!!!!
Maybe i just need to give these a little longer to bed in???? But thought i'd just ask in the meantime.
Thanks Guys
The pads have the baffle pads on the backs and copper ease plastered all over them so i was hoping this would stop this. BUT NO!
Has anyone had problems with these type, as i was told they would not screech, and at present i sould like a bloody black cab!!!!!!
Maybe i just need to give these a little longer to bed in???? But thought i'd just ask in the meantime.
Thanks Guys
Edited by silver cerbie on Sunday 27th August 16:30
I have them on mine.
I put the sticky pads provided by Mintex on the back, and a good dose of copperslip on the back. Sounds like you've done this?
Have you followed the bedding in procedure in the leaflet with the pads?
Repeat this every so often and they should behave themselves. A good run with some really hard braking usually sorts them out!
Hi, I am assuming you mean the 10 progresivley hard stops from 70-5MPH without stopping Etc etc!
Yeah i did this with the first set, but they still screeched! Must admit never heard of this kind of bedding in! Didn't want to over do it what with the new discs.....didn't want to warp them!
Ok well thanks, will try with new ones a bit more bedding in a see from there!
Yeah i did this with the first set, but they still screeched! Must admit never heard of this kind of bedding in! Didn't want to over do it what with the new discs.....didn't want to warp them!
Ok well thanks, will try with new ones a bit more bedding in a see from there!
Davislove said:
Lotus spend a fortune developing suitable brake pad material for road / track use, my advice is take them off and fit standard, I tried with Mintex on a previous car and they will always be noisy because of the compound used
I dont think Lotus even spend a penny develpoing pads.
They just got the whole braking system from manufacturers that met their requirements.
The standard Brembo pads are crap.
You just press the pedal and nothing happens.
They also dont last well on the track.
Pagid RS42's are the way to go.
Expensive and sometimes noisy in town, but amazing feeling and fadeless stopping ability.
silver cerbie said:
I have just upgraded my front brakes to Mintex 1144, and also had new drilled & grooved discs. on my lotus elise S1. The problem is the pads are really really sreeching on soft braking! Had a new pair sent as a replacement and although not bedded in yet, the sreeching has already started to creep in!
The pads have the baffle pads on the backs and copper ease plastered all over them so i was hoping this would stop this. BUT NO!
Has anyone had problems with these type, as i was told they would not screech, and at present i sould like a bloody black cab!!!!!!
Maybe i just need to give these a little longer to bed in???? But thought i'd just ask in the meantime.
Thanks Guys
The pads have the baffle pads on the backs and copper ease plastered all over them so i was hoping this would stop this. BUT NO!
Has anyone had problems with these type, as i was told they would not screech, and at present i sould like a bloody black cab!!!!!!
Maybe i just need to give these a little longer to bed in???? But thought i'd just ask in the meantime.
Thanks Guys
Edited by silver cerbie on Sunday 27th August 16:30
Hi there, I use Mintex 1166 pads in the Esprit and experience the same problems even after correct bedding in etc. I was told by the racing specialists who sold me these pads to really stomp on the pedal very hard every now and again especially while not using the car on the track. What happens (in my situation) I drive the car around town or round the block and use the brakes sparingly or very light on the pedals at cruising pace. The face of the pad eventually glazes over causing it to squeak or sounds like the pads have worn down to the pins. So what I do is go down a quiet street or somewhere out of harms way for a spirited run, make sure no body is behind and stand hard on the brakes like you would if you’re racing. You might have to do this two or three times to take the glazing off. Viola all gone !!
Hope this helps.
The bedding in technique described by Mintex is a standard bedding in technique for any kind of slightly higher performance pad.
I run 1144s. They squeal - so what? Show me a rally car or Le Mans GT3 car that doesn't have squealing pads.......
The Elise isn't exactly a 'wafting' kind of car anyway, plus the lack of soundproofing exacerbates the volume.
You can shut them up a bit by re-bedding them in. 60-standstill maybe 5 times in rapid succession. Left foot brake at about 60 for a good few seconds (10-15 seconds). A few 'big stops' from private test track speeds down to walking pace is always a good idea too.
I run 1144s. They squeal - so what? Show me a rally car or Le Mans GT3 car that doesn't have squealing pads.......
The Elise isn't exactly a 'wafting' kind of car anyway, plus the lack of soundproofing exacerbates the volume.
You can shut them up a bit by re-bedding them in. 60-standstill maybe 5 times in rapid succession. Left foot brake at about 60 for a good few seconds (10-15 seconds). A few 'big stops' from private test track speeds down to walking pace is always a good idea too.
tuscan_thunder said:
I run 1144s. They squeal - so what? Show me a rally car or Le Mans GT3 car that doesn't have squealing pads.......
I love that!!
I think about this when my brakes squeek, I also have mintex 1144's all round. I just think to myself I've got my very own racing car!! I think it adds to the character of the car!!
Ok Guys, thank you all for your advice.
Took it out last night and gave it some welly (Obviously within the speed limits) lol, and yeah they didn't make a sound. Drove into town today and was taking it easy, and yep they started to make some noise. Guess i'll have to keep my driving to the aforementioned only!
Had the standard pads on before, and they were pretty awful! Wasn't till i drove my bro's Noble that i realised how bad they were!
Cheers all.
Scott
Took it out last night and gave it some welly (Obviously within the speed limits) lol, and yeah they didn't make a sound. Drove into town today and was taking it easy, and yep they started to make some noise. Guess i'll have to keep my driving to the aforementioned only!
Had the standard pads on before, and they were pretty awful! Wasn't till i drove my bro's Noble that i realised how bad they were!
Cheers all.
Scott
Gassing Station | Elise/Exige/Europa/340R | Top of Page | What's New | My Stuff


