Hi reving elise
Author
Discussion

boobles

Original Poster:

15,251 posts

246 months

Monday 28th August 2006
quotequote all
I seem to have an over reving elise s1. It just started today as i came of the motorway.. Every time i put the clutch in to change gear, it stays reving quite high at around 2000 revs! The only way to bring them back down is to rev it even higher, then they drop right down. It does it every time i change gear & if i slow down in fourth to around 25mph, the car tries to speed up without me actually touching the accelerator. Please help....

tuscan_thunder

1,763 posts

277 months

Monday 28th August 2006
quotequote all
sticking throttle body or idle air control valve.

grease the throttle linkage (pedal and throttle body end), and take out the idle air control valve (its a wee electronic thing in the intake manifold) and clean it with carb cleaner and then WD40. (if you pull it out, get someone to turn the ignition on and off BE CAREFUL and you should see the valve operate)

boobles

Original Poster:

15,251 posts

246 months

Monday 28th August 2006
quotequote all
After having a look today, its obvious its the accelerator cable sticking, but how do i fix this & stop it from happening?
Do i adjust it, or leave well alone?

Paul RN

1,168 posts

245 months

Monday 28th August 2006
quotequote all
Sounds more like the throttle body, does it only stick when its warmed up?

boobles

Original Poster:

15,251 posts

246 months

Monday 28th August 2006
quotequote all
It did it only when warm mate, but after taking tuscan thunders advice, i bought some decent grease & lubricated all the throttle linkages & surrounding areas, & seems to be running fine again! Even got it nice & hot, but still no over reving, so fingers crossed & thanks for the help guys, much appreciated & i shall keep my eye on it, & try all the other suggestions if the problem comes back.. Cheers guys.driving

Paul RN

1,168 posts

245 months

Monday 28th August 2006
quotequote all
boobles said:
It did it only when warm mate, but after taking tuscan thunders advice, i bought some decent grease & lubricated all the throttle linkages & surrounding areas, & seems to be running fine again! Even got it nice & hot, but still no over reving, so fingers crossed & thanks for the help guys, much appreciated & i shall keep my eye on it, & try all the other suggestions if the problem comes back.. Cheers guys.driving


If it only happen when its worn it wouldn't be the throttle cable it would be the plastic throttle bodies. Although not to worry if you've sorted it, get ourt there and drive it!