S2 replacement indicator light fitting
S2 replacement indicator light fitting
Author
Discussion

mattrjpool

Original Poster:

38 posts

257 months

Monday 4th September 2006
quotequote all
Was out driving yesterday afternoon driving at speed, when my front drivers side indicator light fitting 'popped' out, bounced about on the front clam for a couple of seconds and then disappeared over the roof never to be seen again!

1, Has this ever happened to anyone before?

2, How do I go about getting a replacement?

3, Any idea on cost?

4, Is it legal to drive without a front indicator?

Thanks

mac1967

205 posts

257 months

Monday 4th September 2006
quotequote all
A common problem with the earlier indicator fittings.Your lucky it didn't bounce around too much and damage the paintwork or worse...even damage the clam!
I thought Lotus had a re-call to change the indicator units as the earlier brackets just wern't quite upto the job.

Sorry, I can't help you with the cost but I believe they arn't exactly cheap.

Give Lotus a call, see what they say about the re-call as I may be wrong about that?

Hope this info helps.

Regards,

Mac

richquy

167 posts

246 months

Monday 4th September 2006
quotequote all
This happened to me about 2 months ago...both popped out whilst at speed - was amazed that no apparent bodywork damage had been done as they were still connected with the wire(s).

I went to order two new units + seals, and it worked out to be approx. £100 per unit from memory.

However, I was told that this was a Lotus product recall - despite my car now being out of warranty (bought brand new March '04), I took it back to the main dealer, and they replaced both free of charge as it was apparently a common fault - the new ones (I believe 111R spec) have a much stronger, and better designed clip.

Suggest you try that.

Stonie

140 posts

253 months

Monday 4th September 2006
quotequote all
"However, I was told that this was a Lotus product recall - despite my car now being out of warranty (bought brand new March '04), I took it back to the main dealer, and they replaced both free of charge as it was apparently a common fault - the new ones (I believe 111R spec) have a much stronger, and better designed clip."

"...a much stronger, and better designed clip." ...YOU MUST BE JOKING !

The pasenger side one on my new '06 111R broke after just 1 week. I didn't bother asking for a replacement under warranty... I looked at them both and thought "CRAP IDEA ALTOGETHER". Both of my indicators are now fastened in permanently, AND, I can still get to the bulbs (for replacement) through the access panel that forms part of the wheel arch liner.

richquy

167 posts

246 months

Monday 4th September 2006
quotequote all
[quote=Stonie...YOU MUST BE JOKING !
[/quote]

You can't have ever seen the attachment method used on cars prior to the 111R then - now they were crap!! It does 'appear' to be much improved, although clearly not utterly faultess in your case. Mine are now secure and I'm happy...until the next time they pop out!

Edited by richquy on Monday 4th September 17:57

weegilly

27 posts

254 months

Tuesday 5th September 2006
quotequote all
The O/side one popped out a while ago so I used the strong double sided tape (also used for No plates) and they ain't going nowhere.
Suprised to see this post though, rang my Dealer about it straight away and they said to come in and they can make a claim, even for the other one.
Rather have the later one's and then add some No plate tape to those for good measure.
And this is an 03 Car.
Finger crossed they accept it then?