lamba oxygen sensor
Discussion
been have probs with my 111s latly when its warm it hunts for the tickover point and genraly donsnt feel well . trade a few things you guys surgested eventually got rond to running it with out the lamba conected and hay presto it all works fine again so i will get new sensor but is it ok to run it with out the sensor conected going away for the weekend realy wanted to take the elise
and all so i think a remember reading some where that some people have had problems with the elise ecu not handleing the upgrades they have done is that right thanks again to everyone that has helped me over the last few weeks
and all so i think a remember reading some where that some people have had problems with the elise ecu not handleing the upgrades they have done is that right thanks again to everyone that has helped me over the last few weeks
I think it is unlikely you will damage the cat, at least for a while, because the ECU will switch from closed loop to open loop control (i.e. it won't use the lambda sensor to influence fueling). What will happen is that an error code will be stored in the ECU, this could be read by diagnostics computer at a lotus/rover garage. I would recommend doing the work though. HTH.
stevie111s said:
I think it is unlikely you will damage the cat, at least for a while, because the ECU will switch from closed loop to open loop control (i.e. it won't use the lambda sensor to influence fueling).
That's why it will damage the cat. The purpose of the lambda sensor is to enable the ECU to maintain lambda=1 to protect the cat.
GreenV8S said:
That's why it will damage the cat. The purpose of the lambda sensor is to enable the ECU to maintain lambda=1 to protect the cat.
Should be no problem for the cat, really..
Even during open loop running most cars are mapped pretty close to lambda=1 in their tables. A tad richer normally to protect the engine, but still close.
Also.. An engine runs open loop quite a lot of the time. Only at steady-state running or very small changes in throttle position can it switch to closed loop.
Only if there's another problem acuaing a massively rich or lean mixture would you get into problems with the cat. Usually thermal problems..
Bye, Arno.
Gassing Station | Elise/Exige/Europa/340R | Top of Page | What's New | My Stuff



