S2 losing water
Discussion
Hi Mark,
There has been a thread on this before but I cant search at the mo.
Mine is similar in the fact that it always sits on or even just below the minimum but cannot I find any leaks/ no contamination either way.
I was expecting the dreaded HGF any day but it has been like this since I got the car. Just monitor it and keep an eye on the temperature guage ( like we all dont anyway!)and I think you will find its a case of TADTS!
The above assumes you have a K series engine and not a yota as I have no experience of those.
HTH
There has been a thread on this before but I cant search at the mo.
Mine is similar in the fact that it always sits on or even just below the minimum but cannot I find any leaks/ no contamination either way.
I was expecting the dreaded HGF any day but it has been like this since I got the car. Just monitor it and keep an eye on the temperature guage ( like we all dont anyway!)and I think you will find its a case of TADTS!
The above assumes you have a K series engine and not a yota as I have no experience of those.
HTH
Yep - deffo the case on S1s. ( K-Series )
If you fill the car to MAX it will simply throw out the excess until it is happy - normally just under the MIN line on cold.
If you want to put your mind at rest, go out and check the level tomorrow morning when the engine is cold. It should be close or at the MIN line. ( Even Lotus say that in the manual ).
Go for a run, keep your eye on the temperature.
Check again the day after. Still close or at the min line?
Then you have a fine car!!!
( One explanation I got once was that Lotus got the expansion chambers from a outside source and did not change the max/min to a more relevant hot/cold - that is how you should think of the lines, as the level will go up and around the max line when hot. You are only interested in the cold readings )
If you fill the car to MAX it will simply throw out the excess until it is happy - normally just under the MIN line on cold.
If you want to put your mind at rest, go out and check the level tomorrow morning when the engine is cold. It should be close or at the MIN line. ( Even Lotus say that in the manual ).
Go for a run, keep your eye on the temperature.
Check again the day after. Still close or at the min line?
Then you have a fine car!!!
( One explanation I got once was that Lotus got the expansion chambers from a outside source and did not change the max/min to a more relevant hot/cold - that is how you should think of the lines, as the level will go up and around the max line when hot. You are only interested in the cold readings )
Gassing Station | Elise/Exige/Europa/340R | Top of Page | What's New | My Stuff



