S2 Exige - Braking moment
Discussion
Had a moment under braking early this morning. Pedal was on the stop before the car eventually came to a halt. I was literally standing on the pedal. Good road surface, no ABS kicked in. Brakes were warmed, not hot. Tried again from slightly lower speeds with less drama but I'm not convinced it's right.
Think I'll upgrade the pads to Mintex anyway, Pagids are OTT for my use. Anyone else experienced this. Fluid was changed by main dealer less than 400 miles ago. Since then I adjusted the brake pedal to raise it about 7-10mm but (in theory) this should reduce travel. Anyone think of anything.
Cheers
Think I'll upgrade the pads to Mintex anyway, Pagids are OTT for my use. Anyone else experienced this. Fluid was changed by main dealer less than 400 miles ago. Since then I adjusted the brake pedal to raise it about 7-10mm but (in theory) this should reduce travel. Anyone think of anything.
Cheers
I had something happen similar to me, however it resulted in a more dramatic outcome. Since then I asked on here if anyone had expereinced same as it appears that the breaks have started not to slow me down initially.
My initial assumption was that the pads were worn, however after taking it to a garage they assured me there was plenty of wear left. I have now adopted the approach of leaving even more space between me and the car in front, as after about second the pads do bite and the car slows as expected, its just that initial second where the slowing of the car seems less than I had initially got used to.
TBH, I think its time to upgrade to the Mintex, or Pagid option and possibly new brake fluid. The car is 2.5yrs old and I beleive the brake fluid is recommended to be changed about now, by those in the know
My initial assumption was that the pads were worn, however after taking it to a garage they assured me there was plenty of wear left. I have now adopted the approach of leaving even more space between me and the car in front, as after about second the pads do bite and the car slows as expected, its just that initial second where the slowing of the car seems less than I had initially got used to.
TBH, I think its time to upgrade to the Mintex, or Pagid option and possibly new brake fluid. The car is 2.5yrs old and I beleive the brake fluid is recommended to be changed about now, by those in the know
Edited by beachbum on Saturday 7th April 09:03
beachbum said:
TBH, I think its time to upgrade to the Mintex, or Pagid option and possibly new brake fluid. The car is 2.5yrs old and I beleive the brake fluid is recommended to be changed about now, by those in the know
2.5 years! I change mine at least twice a year. Bleed after every track outing. You definitely need a fluid change.
shangani said:
beachbum said:
TBH, I think its time to upgrade to the Mintex, or Pagid option and possibly new brake fluid. The car is 2.5yrs old and I beleive the brake fluid is recommended to be changed about now, by those in the know
2.5 years! I change mine at least twice a year. Bleed after every track outing. You definitely need a fluid change.
OK so about to ask a Q, that will show just how inknowledgable I truely am, but when it comes to brakes, ignorance is not bliss.
Why does brake fluid require changing so often on an Elise. Most if not all cars hardly ever require the fluid to be changed, so what makes the Lotus's different ?
beachbum said:
shangani said:
beachbum said:
TBH, I think its time to upgrade to the Mintex, or Pagid option and possibly new brake fluid. The car is 2.5yrs old and I beleive the brake fluid is recommended to be changed about now, by those in the know
2.5 years! I change mine at least twice a year. Bleed after every track outing. You definitely need a fluid change.
OK so about to ask a Q, that will show just how inknowledgable I truely am, but when it comes to brakes, ignorance is not bliss.
Why does brake fluid require changing so often on an Elise. Most if not all cars hardly ever require the fluid to be changed, so what makes the Lotus's different ?
I base this answer purely on what I know (which isn't much!)
Over time brake fluid absorbs oxygen which eventually forms small bubbles. When you press the brake pedal the bubbles in the fluid compress rather than the fluid being forced to exert pressure within the calliper pistons. This means you get a % of compression before brake pressure is applied leading to a spongy pedal.
The older the fluid the more oxygen so good practice to change fluid at a timed interval anyway.
But... when the brake fluid gets hot or overheats under extreme conditions, ie. track use or harsh road
gas bubbles can form quite rapidly. Hence, track use, change very frequently. As Lotus' and most other performance cars tend to be driven harder than your average Mondeo the fluid is more prone to breakdown and therefore is more likely to need replacing more frequently.
Does this make sense?
Edited by 21TonyK on Sunday 8th April 10:03
21TonyK said:
Pedal was on the stop before the car eventually came to a halt.
Do you mean that the pedal had gone to the floor? That suggests that you had air in the system, or a leaking seal. If you aren't losing fluid, the most likely place for a leaking seal is the master cylinder internal seals.
TIPPER said:
Tony, you've only just got that car. I'd take it back to the dealers first thing Tuesday morning mate. Brake pedals should not go to the floor. Period.
Exactamundo. Yes, non-silicone brake fluid is hygroscopic and eventually will absorb enough water to lower its boiling point to temperatures achievable on track or *mental* road driving, but you don't really hear that many reports of people boiling their brake fluid on the road, especially with regularly-serviced lightweight things like Elises. Brake fluid does not 'go off' in the space of a week or two.
Personally I'd take it bloody easy until the reason is diagnosed and fixed. If there's a leak somewhere or a big bubble of air sitting in the system somewhere, then it will do it again next time you need to apply serious pressure, and usually the times you need to do this are times you *need* the brakes to function properly.
Hope you get it sorted, and be careful out there until it is!

beachbum said:
Why does brake fluid require changing so often on an Elise. Most if not all cars hardly ever require the fluid to be changed, so what makes the Lotus's different ?
I tracked my car more than 20 times last year, so frequent fluid changes were essential. For a road car, annual fluid change is usually fine. Put "most cars" on track and they would run into serious brake problems fairly quickly, especially if the fluid is years old and has a low boiling point. Although not that common, fluid fade (boiled brake fluid) is not fun - pedal hits floor, no braking at all. (Has warning signs before this happens).
When the brake pedal gets spongy, it is time to bleed the bubbles out of the brake system.
I should clarify my first post. I was braking from ???mph to 0 as hard as possible to see how effective the brakes were, check for dive and squirm. Literally sprinted up to ??? and stood on the brakes. By the time I reached 0 the pedal had definitely reached the end of its travel.
Under normal braking, say slowing from 50 to 30 at a reasonable pace things are okay. Its the hard braking, especially from high speed that I am concerned about. The brakes don't feel progressive and I wouldn't fancy tracking the car as it is.
Under normal braking, say slowing from 50 to 30 at a reasonable pace things are okay. Its the hard braking, especially from high speed that I am concerned about. The brakes don't feel progressive and I wouldn't fancy tracking the car as it is.
My S2 Exige is exhibiting the same symptoms at the moment, it started during the LoT track day at Donnington last month. The bite point used to be quite close to the top of the pedal travel, now it is much lower. I find myself pumping the pedal when stopping the car on the road at the moment. It feels like air in the brakes to me - going to have them bled and replace with race spec. fluid. Fingers crossed that'll sort them - wouldn't go on track with them as they stand.
The car is nearly two years old and I would expect that it is still running the original fluid. The pads are Pagid RS42's with plenty of pad left.
The car is nearly two years old and I would expect that it is still running the original fluid. The pads are Pagid RS42's with plenty of pad left.
mako111 said:
My S2 Exige is exhibiting the same symptoms at the moment, it started during the LoT track day at Donnington last month. The bite point used to be quite close to the top of the pedal travel, now it is much lower. I find myself pumping the pedal when stopping the car on the road at the moment. It feels like air in the brakes to me - going to have them bled and replace with race spec. fluid. Fingers crossed that'll sort them - wouldn't go on track with them as they stand.
The car is nearly two years old and I would expect that it is still running the original fluid. The pads are Pagid RS42's with plenty of pad left.
The car is nearly two years old and I would expect that it is still running the original fluid. The pads are Pagid RS42's with plenty of pad left.
I've got the wheels off right now and there's at least 6/7mm of pad left back and front. The discs aren't scored or marked in any way. The fluid is clean and bright green, dealer stamp for fluid change in the book less than 500 miles ago.
If it's the same next week I'll be changing the fluid myself to see if that sorts it.
GJOB: While the wheels are off I may as well paint the disk bells (I did the engine cover yesterday).
Top tip: Invert the calipers during the bleeding process - you will get out a lot more air bubbles.
Have a look in the wiki for step by step instructions courtesy of Hans Baumhardt:
http://wiki.seloc.org/a/How_to_bleed_
Have a look in the wiki for step by step instructions courtesy of Hans Baumhardt:
http://wiki.seloc.org/a/How_to_bleed_
Edited by shangani on Monday 9th April 14:43
shangani said:
Top tip: Invert the calipers during the bleeding process - you will get out a lot more air bubbles.
Have a look in the wiki for step by step instructions courtesy of Hans Baumhardt:
http://wiki.seloc.org/a/How_to_bleed_
Have a look in the wiki for step by step instructions courtesy of Hans Baumhardt:
http://wiki.seloc.org/a/How_to_bleed_
Edited by shangani on Monday 9th April 14:43
Cheers I believe you changed your hoses for stainless? Looking at the mechanics of it the rears look simple enough but is there a specific tool for the non-caliper end on the fronts or do you just swear a lot and dismantle half the front wheel arch to get to it? A wiki for changing them doesn't seem to exist (yet?)
If I'm doing the fluid I may as well do the pads and hoses. If the problem still remains the cars going to be away for a few weeks in the body shop anyway so it can go back to the supplying dealer to be checked.
shangani said:
21TonyK said:
or do you just swear a lot and dismantle half the front wheel arch to get to it?
That's pretty much the technique - the swearing a lot part anyway.
Alternatively go to Plans and they will do fluid + fit hoses + bleed etc for under £200
I'll have a fiddle tomorrow and see if I can get access to the front hose. If not the car will be in Reading for the paint soon so could always go to Plans afterwards for while-you-wait job.
Did you get a discount, their site says £250 for hoses?
Gassing Station | Elise/Exige/Europa/340R | Top of Page | What's New | My Stuff


