Bedding brakes?
Author
Discussion

21TonyK

Original Poster:

13,415 posts

240 months

Sunday 8th April 2007
quotequote all
Used a combination of the SELOC wiki method and the Pagid, ie. looped up and down between two roundabouts about 500m apart braking from 50/60 to 20 each time then had to carry on from the last slow for about 1.5 miles to a longer stretch with a lay by. Dragged the brakes a little on the way to keep the heat in them and then did a hard stop from 70/80 to 0 in the lay by and held the brakes down hard for a couple of minutes.

Then drove the 5 miles home and brakes felt about 10% better

Anyone got any clever ideas other than changing pads?


shangani

3,069 posts

268 months

Sunday 8th April 2007
quotequote all
Sounds fine except for the bit about holding the brakes down hard for a couple of minutes when they are really hot - great way to warp your discs.

21TonyK

Original Poster:

13,415 posts

240 months

Sunday 8th April 2007
quotequote all
shangani said:
Sounds fine except for the bit about holding the brakes down hard for a couple of minutes when they are really hot - great way to warp your discs.


Bugger! That was the bid from the Pagid site! I'm really starting to think I need to change pads and then bleed the fluid (although this was changed recently by dealer). After that if it's not right I'll put it into a dealer to get them checked out.

Every time I brake hard to rest the pedal is on the stop. Feels like I'm going to bend the pedal!

tanman

505 posts

266 months

Sunday 8th April 2007
quotequote all
Hi Tony, i'd be inclined to get this checked out asap at a garage, if the brakes are not right is it really worth trying to find the probelm yourself and risk smashing your lovely new car (or worse- you) in the mean time?
Whats happening on the paint front? who is going to do it for you? how much?????
All the best
Tanman

21TonyK

Original Poster:

13,415 posts

240 months

Sunday 8th April 2007
quotequote all
tanman said:
Hi Tony, i'd be inclined to get this checked out asap at a garage, if the brakes are not right is it really worth trying to find the probelm yourself and risk smashing your lovely new car (or worse- you) in the mean time?
Whats happening on the paint front? who is going to do it for you? how much?????
All the best
Tanman


Passed it over to "AnniesDad" to deal with. Going to Specialised Paintwork, circa £1.5-£1.7K with the Armourfend then a loan Lotus or something similar for a couple of weeks so looking at about £3.5K + VAT all in.

Should have gone to chips-away

tanman

505 posts

266 months

Sunday 8th April 2007
quotequote all
21TonyK said:

Passed it over to "AnniesDad" to deal with. Going to Specialised Paintwork, circa £1.5-£1.7K with the Armourfend then a loan Lotus or something similar for a couple of weeks so looking at about £3.5K + VAT all in.



Excellent stuff tony, AnniesDad-legend, specialised-legends, £3.5K?- good effort for a little chip
Tanman

21TonyK

Original Poster:

13,415 posts

240 months

Sunday 8th April 2007
quotequote all
tanman said:
21TonyK said:

Passed it over to "AnniesDad" to deal with. Going to Specialised Paintwork, circa £1.5-£1.7K with the Armourfend then a loan Lotus or something similar for a couple of weeks so looking at about £3.5K + VAT all in.



Excellent stuff tony, AnniesDad-legend, specialised-legends, £3.5K?- good effort for a little chip
Tanman


Gone right of stripes now though laugh

glacierblue

30 posts

242 months

Tuesday 10th April 2007
quotequote all
or you could take it to a local southern dealer who will drive it at 120mph ish and when cought by the the owner claim that they had to go that fast to bed in the brakes. i did get a discount on the service though....

tricky 100

954 posts

273 months

Tuesday 10th April 2007
quotequote all
21TonyK said:
Used a combination of the SELOC wiki method and the Pagid, ie. looped up and down between two roundabouts about 500m apart braking from 50/60 to 20 each time then had to carry on from the last slow for about 1.5 miles to a longer stretch with a lay by. Dragged the brakes a little on the way to keep the heat in them and then did a hard stop from 70/80 to 0 in the lay by and held the brakes down hard for a couple of minutes.

Then drove the 5 miles home and brakes felt about 10% better

Anyone got any clever ideas other than changing pads?



Sorry but sounds like your looking for problems that aren't really there .If your brake pedal went all the way to the stop on the floor ie, you had no more travel in the pedal then you need to see a garage as this usually indicates a problem with the master cylinder . This can happen after the fluid has been changed , sometimes the person bleeding the brakes will pump the pedal all the way down causing damage to the piston seal , resulting in air entering the system and causing the pedal to go all the way down intermitantly .
Or you have read to many threads about so called "chessium discs and pads " when really standard discs and pads are perfectly fine for road use and the occasional track day .

Gooby

9,269 posts

265 months

Tuesday 10th April 2007
quotequote all
21TonyK said:


Gone right of stripes now though laugh


cool Stripes - warpaint for your Lotus!

TIPPER

2,955 posts

250 months

Tuesday 10th April 2007
quotequote all
Please Tony get that car to a garage. Something is not right with your brakes.

21TonyK

Original Poster:

13,415 posts

240 months

Tuesday 10th April 2007
quotequote all
TIPPER said:
Please Tony get that car to a garage. Something is not right with your brakes.


Been p*ssing about all day with it. Done a complete fluid change, checked the pads. 100% there is no air in it. No bite until pedal is 2/3 down and only then do you start to feel any sense of slowing.

It's off to Peninsula on Friday. X5 until then

Best bit is the "paint engineer" (don't know what else to call him) came out today and agreed a total font clam respray was needed. So, looks like I've got a two week old car with shagged brakes and a dodgy paint job!

Oh well, such is life.

tricky 100

954 posts

273 months

Tuesday 10th April 2007
quotequote all
21TonyK said:
TIPPER said:
Please Tony get that car to a garage. Something is not right with your brakes.


Been p*ssing about all day with it. Done a complete fluid change, checked the pads. 100% there is no air in it. No bite until pedal is 2/3 down and only then do you start to feel any sense of slowing.

It's off to Peninsula on Friday. X5 until then

Best bit is the "paint engineer" (don't know what else to call him) came out today and agreed a total font clam respray was needed. So, looks like I've got a two week old car with shagged brakes and a dodgy paint job!

Oh well, such is life.

Dont tell them you have been pissing about with the brakes or they wont touch it under warranty .

21TonyK

Original Poster:

13,415 posts

240 months

Tuesday 10th April 2007
quotequote all
tricky 100 said:
21TonyK said:
TIPPER said:
Please Tony get that car to a garage. Something is not right with your brakes.


Been p*ssing about all day with it. Done a complete fluid change, checked the pads. 100% there is no air in it. No bite until pedal is 2/3 down and only then do you start to feel any sense of slowing.

It's off to Peninsula on Friday. X5 until then

Best bit is the "paint engineer" (don't know what else to call him) came out today and agreed a total font clam respray was needed. So, looks like I've got a two week old car with shagged brakes and a dodgy paint job!

Oh well, such is life.

Dont tell them you have been pissing about with the brakes or they wont touch it under warranty .


Only took the wheels off to paint the disk bells... "honest guv'"

Bill K 111

134 posts

244 months

Tuesday 10th April 2007
quotequote all
I dont know if this helps but...I realise that you haven't introduced air into the system, but earlier this year I changed pads and braided hoses so I needed to chase air out of the system. Was completed convinced (after 1.5 litres bubble free fluid flushed through all the brakes, turning the calipers upside down etc) that I absolutely positively had no air in the system. Off for a test drive and the brakes were OK but not great. Pedal bite was 3/4 pedal height but dropped to less than half at hard braking and there was no danger from hitting your head on the dashboard! I couldn't understand it. Posted my woes on here. Arno responded. Went out and did EXACTLY what he said (although fiddly in an 80s game of twister kind of way.) The difference? Night and day. Pedal so good it's now hard to heel and toe unless you are braking on the limit as the pedal hardly moves. And I thought I had no air in the system.
To save you searching I have posted Arno's original response here (and I believe Hans has uploaded it to his site.)

Good luck

Bill K

Tap on the calipers and hoses gently with a plastic hammer to dislodge any bubbles that adhere to the surface

Get some (very)worn brake pads. Fit these to the front calipers and press the pedal a few times to extend the pistons. This will fill them up with fluid.

Now put the pressure bleeder on the reservoir and put some light pressure on it. Not too much or you can pop the pistons out in the next step.

Remove a front calipher, invert it open the bleed nipple and tape the brake hoses gently and also tap on the inside of the caliper.

Then (with your hands) squeeze the INNER piston in. This will empty the inner piston and force the bubbles to the front one. Make sure you push it completely in.

Now carefully rotate the piston normal side up again. Try to turn it so any bubbles in the outer piston will not try to go up the connecting pipe again.

Now tap the calipher again and squeeze the OUTER piston back into the calipher. Once it's fully in, close the bleed nipple and do the other side.

You should get some extra bubbles out.

For the rear brakes make sure you screw the pistons completely back into the calipher before you bleed them.

Also don't skimp on the amount of fluid. Get 2L and work your way through it.

Usually when fitting braided brake hoses I 'cheat' a little by fitting the worn old pads first and then filling up the calipers with brake fluid.

I then remove 1 old hose, fit the new one to the caliper, push back the piston until the brake fluid has filled the hose and is coming out the top and then re-connect it to the car. Often I'll then bleed that one immediately befroe doing the next corner.

This results in only a few bubbles introduced in the system, instead of the whole brake hose that's full of air and needs to be bled out through the calipers..

Bye, Arno.

21TonyK

Original Poster:

13,415 posts

240 months

Wednesday 11th April 2007
quotequote all
Cheers Bill / Arno

Slight variation on yesterdays attempt so while the wheels are off I'll have another go today.

21TonyK

Original Poster:

13,415 posts

240 months

Wednesday 11th April 2007
quotequote all
After 3 litres of fluid (mainly in the drive and in my trainers) a few skinned knuckles and a set of home-made dummy front pads I have working brakes!

I'm sure they're not as good as they could be as I didn't take the rear calipers off. But did the fronts properly and air did come out, quite a lot in fact.

So, the car now stops and the pedal only goes 2/3 of its full travel to do so. I shall order a set of Mintex pads and do the rear calipers another day. The trick with the worn pads (or 5mm ply as I did) works a treat.

Cheers!

TIPPER

2,955 posts

250 months

Wednesday 11th April 2007
quotequote all
Pleased to hear things are going in the right direction for you Tony. Must be very frustrating!

21TonyK

Original Poster:

13,415 posts

240 months

Wednesday 11th April 2007
quotequote all
TIPPER said:
Pleased to hear things are going in the right direction for you Tony. Must be very frustrating!


Yeah, but, hey-ho, such is life! I've ordered a set of Mintex tonight so as and when they roll-up I'll redo the pads and fluid again (albeit less than 5 miles old!).

At least then I know whats-what in braking terms. Then the car will disappear for a couple of weeks to get the paint sorted at Specialised.

The upside is that Plans are just down the road from Specialised so a stainless hose set and a full geo might be in order plus a couple of hours with tuition on their track.

Every cloud has a silver lining...

Bill K 111

134 posts

244 months

Wednesday 11th April 2007
quotequote all
Glad it worked. Amazing isn't it?

Makes you wonder how many other Lotus owners are driving around with OKish brakes without realising they could be so much better.