'Weaving' after new rear tyres fitetd....
'Weaving' after new rear tyres fitetd....
Author
Discussion

oskypuss

Original Poster:

10 posts

267 months

Monday 16th April 2007
quotequote all
I had a new replacement pair of Bridgestone Potenzas fitted to my rear wheels last week, and since then the car is an absolute bugger to keep in a straight line....I can feel the front end weaving around at speed. I have the same tyres (Potenzas) on the front, though they're not new they have a good 2-2.5mm of tread left.

The wheels are tight on (no wobble), and I'm just stumped....what could be the cause of this, and do I need to get some new tyres on the front too? Could it just be a case of waiting to get the new tyres 'scrubbed in?' I don't remember this happening the last time I got some new rear tyres...

I'd be grateful for any light anyone could shed on this!

Thanks.

tanman

505 posts

266 months

Monday 16th April 2007
quotequote all
Are they on the correct way? i think the tyres are directional (check tread patterns with the ones on the front). I think someone else had this problem and discovered the left was on the right and the right was on the left so were the wrong was a round.
HTH
Tanman

oskypuss

Original Poster:

10 posts

267 months

Monday 16th April 2007
quotequote all
They are on the right way, yes....I'm stumped!!!

S works

10,166 posts

281 months

Monday 16th April 2007
quotequote all
Have you checked the tyre pressures on the rears?

tanman

505 posts

266 months

Monday 16th April 2007
quotequote all
Hmmm. Did you watch them change the tyres? (ie anything unusual) Was any adjustments done to the Geo?
You describe the car weaving at high speed, i had this on my old Elise after my shite local dealer decided to adjust the geo despite not asking me first (it was fine until they adjusted it). Ended up taking it to another dealer 100 miles away who said there was far too much tow out on the front wheels which caused the same feeling as what you are describing.
As above, check tyre pressures first as this can make a large difference, then maybe get someone to check the geo settings.
Tanman

bogie

17,109 posts

303 months

Monday 16th April 2007
quotequote all
check the tyre pressures, and then give them 200 miles or so to bed in - Ive had this before...its very disconcerting, but it went away once the "bobbles" had worn off the new tyres

oskypuss

Original Poster:

10 posts

267 months

Monday 16th April 2007
quotequote all
Thanks for your thoughts on this everyone!

I did watch the tyres being changed, and other than a rather surprising number of weights on both wheels following the balancing, everything seemed normal.

I'll go and double-check the pressures, and give them a bit of time to 'de-bobble!'

Cheers again.

S works

10,166 posts

281 months

Monday 16th April 2007
quotequote all
bogie said:
check the tyre pressures, and then give them 200 miles or so to bed in - Ive had this before...its very disconcerting, but it went away once the "bobbles" had worn off the new tyres

Ding. Same with mine when I put the T1-Rs on. They were positively scary above 60mph for the first few hundred miles. A sound ragging at North Weald soon sorted that out

Mark B

1,671 posts

296 months

Monday 16th April 2007
quotequote all
Do a couple of heat cycles and let them bed in.... Surprising number of tyre related threads recently, new tyres seem to feel strange initially and will bed in after 500 miles, ish.... Don't worry too much, it's a light weight car which will exagerate any feelings... It'll go....

The heat cycles will help the tyres 'cure' and all the release agents, excessive silicon will be worn away....

Go drive it....

steff

1,421 posts

294 months

Monday 16th April 2007
quotequote all
oskypuss said:


I did watch the tyres being changed, and other than a rather surprising number of weights on both wheels following the balancing, everything seemed normal.


I'd get the balancing checked.

hbaumhardt

950 posts

310 months

Monday 16th April 2007
quotequote all
Dont panic. I have been told by several tyre fitters who see a lot of Elises that the Lotus (Rimstock but especially OZ) rims are generally really poor for balance and need a LOT of weights.