Number plate Removal (Suggestions)
Discussion
shangani said:
Hairdryer to warm up, or leave in the sun. Then if you are careful, it should just peel away - double sided tape. Worked for me. Velcro works great.
Cheer's Shangani,
Was going to use but wanted to know if anyone had already attempted it, any idea's on where the best place is to get Velcro? think Tim also uses it
Boggy
subaqua said:
Gooby said:
take a long, sharp kitchen knife and slice down the number plate NOT CLAM!!!. then use autoglym tar remover to remove the stuff left on the clam...
Tired all sorts to get the foam stuff off, the tried an old bit of Megiars Quik clay... 2 minute job.
I have left my tape on, it helps when a copper pulls you over to ask where the the numper plate is!
Gooby said:
subaqua said:
Gooby said:
take a long, sharp kitchen knife and slice down the number plate NOT CLAM!!!. then use autoglym tar remover to remove the stuff left on the clam...
Tired all sorts to get the foam stuff off, the tried an old bit of Megiars Quik clay... 2 minute job.
I have left my tape on, it helps when a copper pulls you over to ask where the the numper plate is!

To clear things up.... I used the clay to ensure that the old foam adhesive tape and any residues from the adhesive used to fix it to the clam were cleaned from the car. I obviously intend to replace with a new numberplate immediately.
(have three or four trips to the continent organised over the next couple of months and we got a load of grief from the gendarmes at e/tunnel at easter when three elises turned up in convoy without front plates - so I have to get something organised)
(have three or four trips to the continent organised over the next couple of months and we got a load of grief from the gendarmes at e/tunnel at easter when three elises turned up in convoy without front plates - so I have to get something organised)
Gassing Station | Elise/Exige/Europa/340R | Top of Page | What's New | My Stuff






