mil question
Author
Discussion

scotte

Original Poster:

372 posts

265 months

Thursday 3rd May 2007
quotequote all
Hi,

Been a while since i have posted sorry.

Got an S2 Exige with stage2 and induction. MIL popped on and went off again after 4 starts. I here this can occur with my setup due to idle revs running higher ?

Anyway, dealer says they have ECU flash to stop MIL flagging. Has anyone else applied this fix or know anything about it ?

Thanks for your help
Scott

edp190

336 posts

240 months

Thursday 3rd May 2007
quotequote all
Hey mate, sorry to here about this. Theres lots on SE about MIL light problems. Didnt seem to help AndyG much! I believe it is caused by the induction. Make sure its well oiled. Thats about as much help as i can give! Good luck, cheers

boggy

4,603 posts

266 months

Thursday 3rd May 2007
quotequote all
Had it myself and it was a nightmare!

It's normally down to a backfire code reading on the Ecu, check and get the code P1302 or something very much like it. It won't be cured by resetting the Ecu and it's probably down to your Pipe (Not quite enough back pressure or slightly to much their is around a 10% tolerance built in but it sound's to me like you've got a little more. Get them to re - load the software on the Ecu

Boggy

scotte

Original Poster:

372 posts

265 months

Thursday 3rd May 2007
quotequote all
thanks for the reply ed & boggy. (will hav a look at SE tips )

If the ECU flash doesnt stop coming on again i will ask dealer to remove induction kit (i like the stage 2 )

Happens when in 6th gear at 20-30mph ... exhaust sounds likes it goes into reverse (if that makes any sense) .... im sure its suppose to i just dont know how to explain the sound ... have heard subaru's sports exhaust do it.

cheers
scott


Edited by scotte on Thursday 3rd May 20:14