WTD while the front clam is off?
WTD while the front clam is off?
Author
Discussion

21TonyK

Original Poster:

13,414 posts

240 months

Monday 7th May 2007
quotequote all
I'm booked in with Specialised for a couple of weeks time for the front clam to be resprayed and have asked Alan if he would mind using stainless fixings when it is replaced (I provide them of course).

I assume life would be easier for them if they remove the font badge anyway so I'm going to ask them to replace it with a black and silver one. Anyone know of a self adhesive one, they all seem to be two pins on the back?

Any other quick bits worth doing? Need to order stuff soon to make sure I've got it all in place for a trip up in a week or so's time.

Cheers

dgr

289 posts

265 months

Monday 7th May 2007
quotequote all
Judging by the number of us that have had the heater blower motor pack up. I'd give that and the resistor pack a check / cautionary replace. The standard radiator is also prone to failure (plastic end tanks leak eventually).

S works

10,166 posts

281 months

Monday 7th May 2007
quotequote all
If you're going to take it off and are desperate to upgrade then replacing the rad with a Proalloy one is probably not a bad move.

The S2 badges are only stuck on, you should be able to order a B&W replacement from hangar111. If they all have the studs just have the guys at SP file them off and affix to the clam with silkaflex or similar. Either that or I'm sure they could drill the clam and fix them with bolts for you.

S works

10,166 posts

281 months

Monday 7th May 2007
quotequote all
Come to think of it, it might also be easier to fit braided hoses while its off if you were considering that?

Paul RN

1,168 posts

245 months

Monday 7th May 2007
quotequote all
SELOC techwiki confirms the above

http://wiki.seloc.org/a/Remove_the_fr

"There are a few other things that can be improved whilst the front clam is off, such as replace the radiator & cooling fans, replace the horn."

david@mediacopy

173 posts

252 months

Monday 7th May 2007
quotequote all
That bit which directs the which way the air blows . . . . Mine is stuck blowing into the footwell, so demist is a pain.

rhy 11s

78 posts

248 months

Tuesday 8th May 2007
quotequote all
Looks like I'll be having the front clam off to replace the heater resistor pack, so I'd be keen to know what you decide to get done in the end.

HORN!: Anyone have any suggestions on a replacement horn? Where to get, and one that's has no reliability issues, etc. And of course, that sounds better than the pathetic OE parp!