S1 coolant change - what do I need to know???
S1 coolant change - what do I need to know???
Author
Discussion

jondude

Original Poster:

2,441 posts

248 months

Tuesday 5th June 2007
quotequote all
Have decided to give this a go myself...how hard can it be??? wink

This is what I think it involves:

Car on ramps, undertray off, remove cap, remove hoses and let drain. Hoses back on, car flat, coolant in chamber.

Start engine, cap still off,let thermostat open, bleed from engine, then rad bleed. Check the temperature does not fluctuate madly, cap on, check again, turn off, watch afternoon tennis.

That's it.


Or is it??? I can see Lotus talk about opening the bleeds before starting the engine, but as I cannot use a fancy circulator beyond the engine pumps, I take it that is a waste of time??

Any tips appreciated!!

jondude

Original Poster:

2,441 posts

248 months

Wednesday 6th June 2007
quotequote all
Up...

offshorematt2

868 posts

247 months

Thursday 7th June 2007
quotequote all
Bleeding can be an 4rse. If you have an early s1, I believe the bleed point near the radiator is not the lowest point in the system making it difficult to get the air out.

Easier method is to run a hose from the return line at the header tank over the side of the car and point it into a drain, then just run the car. Keep topping up the header tank with clean water until the returns from the return hose are coming back clean. If you don't let the level drop out of the header tank, you can't introduce air to the system. Once you're happy the system is flushed continue the same way but top the system up with coolant instead of water till its all the way round. Easy.

Maybe not the official way but I can't see a downside and I've done it twice on my old car without problems...

jondude

Original Poster:

2,441 posts

248 months

Thursday 7th June 2007
quotequote all
Thanks for that - must admit, that sounds a clever and ingenious way to do it.

I always did think it made more sense to purge coolant, rather than drain, allow air in, then have the problem of getting rid of the air.

( Bit like changing the brake fluid - purging it is a million times easier than draining and then removing the air )

I'll read that advice again and seriously consider it!