replacing ball joints - easy job????
replacing ball joints - easy job????
Author
Discussion

jimmy2scoop

Original Poster:

54 posts

246 months

Tuesday 19th June 2007
quotequote all
well what do people think?? any complications etc?

2scoop

Muncher

12,235 posts

280 months

Tuesday 19th June 2007
quotequote all
You'll need a tool for pressing them out of the wishbone which I think you can get from EliseParts, but it's not an especially tough job.

jimmy2scoop

Original Poster:

54 posts

246 months

Wednesday 20th June 2007
quotequote all
thanks Muncher,

has anyone out there done a ball joint replacement, a rough guide of steps would be very helpful?!


thanks muchly
2scoops

stevie111s

123 posts

266 months

Wednesday 20th June 2007
quotequote all
Yes, I've done it on my S1 111s and now on my S1 Sport 160. The easiest way to do it is to remove the offending wishbone complete ... just undo the inner suspension bolts and slide them out. Thus remove the wishbone and take, with new vauxhall ball joint, to any garage (check first). The one I use charges me a pint per joint. With the joint at about £17 it's a whole lot cheaper that taking it to a dealer. HTH

As for steps, here goes:
1 remove roadwheel
2 remove steel plinth from ally hub carrier, bottom ones are 4 bolts, tops are 2 hex studs (if tops save the spacers carefully)
3 remove 2 inner wishbone pivot bolts and withdraw
4 withdraw wishbone making sure brake hose is not put under stress when wb removed
5 take wishbone and balljoint to a garage
6 re-assemble in reverse procedure. Note that you should use the yellow anti-corrosion paint on all ally to steel joints, and locking compound on all bolts that go into ally. I have found, however, that so long as you torque up the bolts correctly (45nm IIR) they will not move even without the locking compound.

If you have a suitable mobile press then you could do this without removing the wishbone.

Edited by stevie111s on Wednesday 20th June 13:13


Edited by stevie111s on Wednesday 20th June 13:16

Bill K 111

134 posts

244 months

Wednesday 20th June 2007
quotequote all
The elise parts ball joint tool is great and very easy to use. The Elise parts balljoints fit nicely too. I too removed the wishbones to do it but then I was replacing the bushes with Nylatrons at the time. It looks possible to do it in situ and certainly worth trying as if you find it too fiddly you'd have already removed what you have to remove to take the wishbone off anyway if you see what I mean.

I notice you are 'South.' If you're anywhere near Gosport you are welcome to borrow my ball joint tool if you like.

Bill K 111

134 posts

244 months

Wednesday 20th June 2007
quotequote all
As Stevie111s suggests you need a mobile press. The good news is that balljoint tool IS a mobile press.