s2 111s timming belt
Discussion
hi i have a 111s s2 and i am fitting a timming belt or should i say timming belts it has a small belt on the left and a bigger one on the right can any one tell me the easiest way to get into the belt on the right and if the rear clam has to come off if it does how do you remove it cheers
Your best bet is to remove the clam, it's not difficult, if you have the manual it shows exactly where the bolts are. You can do the main belt without removing the clam, remove the rear off-side wheel, then remove the inner wheel arch. This will give enough access but it's not as easy.
I did my 111s belts, it's a snip so you'll have no problem, just remember to lock the sprockets (I made a little tool to do this) and lock the crank (also made a little tool) via the starter motor aperture. Any Q's I might be able to help.
Good luck
I did my 111s belts, it's a snip so you'll have no problem, just remember to lock the sprockets (I made a little tool to do this) and lock the crank (also made a little tool) via the starter motor aperture. Any Q's I might be able to help.
Good luck
I did this job recently...no need to remove the clam. You will need a shallow 22mm socket for the crankshaft pulley bolt - it's not too difficult to cut one down with an angle grinder. The other tool that hasn't been mentioned is an 8mm allen socket for the tensioner.
Oh, and make sure you get the right belt...they come in 23 and 26mm flavours.
Good luck,
Steve
Oh, and make sure you get the right belt...they come in 23 and 26mm flavours.
Good luck,
Steve
Edited by Stevie P on Friday 29th June 15:55
Gassing Station | Elise/Exige/Europa/340R | Top of Page | What's New | My Stuff



