Covering air vents with stockings?
Covering air vents with stockings?
Author
Discussion

sequential

Original Poster:

70 posts

243 months

Monday 9th July 2007
quotequote all
I remember reading a while back about covering the air inlet vent with ladies stockings to prevent dust, leaves and other gremlins getting in. I've performed a search, but no specifics are available. Where exactly is the vent on a 2006 Elise R? Is this easy to do, or is it a clam-off job?

bing

1,946 posts

269 months

Monday 9th July 2007
quotequote all
only do this if the lady is HOT and willing to strip-off her stockings!!!!

Gooby

9,269 posts

265 months

Monday 9th July 2007
quotequote all
Take the front grill out (set of clips) and look in. The air intakes are there below the fans. Personally I wont do it because if the stocking becomes loose it will snarl the fans.

sequential

Original Poster:

70 posts

243 months

Monday 9th July 2007
quotequote all
Great, thx Gooby. The potential for stockings working loose leads to my next question -- is there any way of securing stockings so they won't come off and jam the fans, or block the vent entirely? My initial thoughts are that duct tape and rubber bands won't suffice? Comments anyone?

Gooby

9,269 posts

265 months

Monday 9th July 2007
quotequote all
sequential said:
Great, thx Gooby. The potential for stockings working loose leads to my next question -- is there any way of securing stockings so they won't come off and jam the fans, or block the vent entirely? My initial thoughts are that duct tape and rubber bands won't suffice? Comments anyone?
From looking at it while I was removing the shattered bits of blackbird, duct tape is about the only option, personally I wouldnt as with the force of air through the intake will lift a corner then a side then you will have problems.

S Works

10,166 posts

281 months

Tuesday 10th July 2007
quotequote all
Isn't there anyway you could fit these at the other end, i.e. somehow gently prize open the ducts from the cabin and do your stocking thang then refit them?

Gooby

9,269 posts

265 months

Tuesday 10th July 2007
quotequote all
S Works said:
Isn't there anyway you could fit these at the other end, i.e. somehow gently prize open the ducts from the cabin and do your stocking thang then refit them?
That would be quite silly, all the sand and grit would be forced to stay within the heater system, eventually clogging it up.

There is a solution, first go over the dash with a feather duster then a microfibre cloth. Removes all rubbisg and leaves it nice and clean.

Grinzzz

566 posts

248 months

Tuesday 10th July 2007
quotequote all
Never looked at the intakes but how about tie wraps? I wouldnt put it on the inside - unless your willing to change the stockings every so often - even then I think Goobs is right, prolly block something else.

Halfrauds do a "magic" cloth, a treated yellow duster. These are terrific at removing any road that makes its way into the cabin.

Gooby

9,269 posts

265 months

Tuesday 10th July 2007
quotequote all
Grinzzz said:
Never looked at the intakes but how about tie wraps? I wouldnt put it on the inside - unless your willing to change the stockings every so often - even then I think Goobs is right, prolly block something else.

Halfrauds do a "magic" cloth, a treated yellow duster. These are terrific at removing any road that makes its way into the cabin.
You can only access 3 sides of the square intakes, you would have to drill the crash structure to use cable ties ..

I should point out that I refer to a 111R only and have not looked at any other variant.

subaqua

892 posts

243 months

Tuesday 10th July 2007
quotequote all
Have resisted joining this thread until now.

Stockings should only be used for their intended purpose, worn by our gorgeous wives/gfs and not used on your Lotus.

Its a PITA but you have to dust the dashboard every now and again, but if you keep the top vents closed unless you need to clear the screen, it keeps the dust down to a minimum.

If we want to keep this as a "best places you have seen stockings" thread thats fine by me, otherwise SEOT tongue out


Edited by subaqua on Tuesday 10th July 10:58

Cuzza

2,042 posts

284 months

Tuesday 10th July 2007
quotequote all
ISTR there's a guy (Tigga) on SELOC who does mesh covers that stop this.

Send him a U2U to see if they'll fit an S2.

Grinzzz

566 posts

248 months

Tuesday 10th July 2007
quotequote all
Cuzza said:
ISTR there's a guy (Tigga) on SELOC who does mesh covers that stop this.

Send him a U2U to see if they'll fit an S2.
I wondered what to do with the carbon filters I have left over - wonder if they're the right size.........

S Works

10,166 posts

281 months

Tuesday 10th July 2007
quotequote all
Gooby said:
S Works said:
Isn't there anyway you could fit these at the other end, i.e. somehow gently prize open the ducts from the cabin and do your stocking thang then refit them?
That would be quite silly, all the sand and grit would be forced to stay within the heater system, eventually clogging it up.

There is a solution, first go over the dash with a feather duster then a microfibre cloth. Removes all rubbisg and leaves it nice and clean.
You're probably right, but then all the crap's getting in there anyway, so if the only criteria is to prevent it entering the cabin I can't see all that much gathering in there... or maybe I'm wrong. I use the "whatever" approach to this and just clean the interior of the car every other week or so.

As soon as the roof comes off it's redundant anyway.

crackthatoff

3,314 posts

244 months

Tuesday 10th July 2007
quotequote all
if anything else starts going wrong, ill be putting one on my head to visit the bank manager !!!

cej

961 posts

253 months

Tuesday 10th July 2007
quotequote all
rofl