Elise S2 Oil Change
Author
Discussion

mathewbet1

Original Poster:

56 posts

241 months

Friday 26th October 2007
quotequote all
Im about to change the oil in my 2003 135 R, its between services but i thought id give it a treat. is it fairy straight forward???

Simply jack up, remove the nuts of rear underside panel with alan key? the bingo? Or is there somthing more I should be aware of. Any advice please thank you.

jondude

2,441 posts

248 months

Friday 26th October 2007
quotequote all
A few of those little but important things:

If you cannot get the undertray off within minutes ( takes quite a while on a S1 ) then take it off and go for a long run. The idea is to drain the oil when it is h-o-t, as this aids the flushing effect.

Make sure you remove the dipstick and oil filler cap before draining - if you don't, the vacuum will slow down the flow, which reduces the flushing, and leaves quite a lot of old oil in the sump.

Priming the oil filter is also a good idea, and don't rev the engine when you start it. Let it idle for 2 minutes, leave for 2, check level again and bring to a mm or two of the max line.

Sorted.

TonyHetherington

32,091 posts

281 months

Friday 26th October 2007
quotequote all
Rememebr, though, that when you undo the sump plug you will have boiling hot oil running over your hand. It hurts.

[/voice of experience]

kevin ritson

3,423 posts

258 months

Friday 26th October 2007
quotequote all
Just needs to be warm - enough to thin it, allowing it to flow through the drain plug easily.

Also make sure you have a really wide container to drain it into, you'd be amazed how messy it can be, even an old oil container with the side cut out can struggle to cope

TonyHetherington

32,091 posts

281 months

Friday 26th October 2007
quotequote all
And remember to inspect the magnetic sump plug too (should be fine)

mathewbet1

Original Poster:

56 posts

241 months

Friday 26th October 2007
quotequote all
Thanks Guys for the advice.......................

chip*

1,877 posts

259 months

Friday 26th October 2007
quotequote all
Step by step guide to do an oil change, and list of tools required plus useful tips for each step:

http://www.tadts.com/instructions/engine/100001.ht...

Hope this helps.

Rgds
Tom