Help please folks!!!!!! I need to find a connector !!!

[silverback mike]

y

Evening all...I'm at a loss. The current in between shed has speakers that sound like vibrating plastic bags so I've bought a set of decent new alpine jobs. However, it's a Nissan and has factory fit connectors, the male brown one is connected to the car, the female speaker one is as pictured. I know you can buy aftermarket connectors that connect to the male with spade connectors that fit on the new speakers but for the life of me I can't find anything to fit. I've looked everywhere and even been int the dealer and of course halfords where I was met by a vacant stare and wet lower lip. Can someone provide a link please!

The car is a v Reg Nissan Almera.....a beauty and worthy to reclaim my title of shedmeister

[silverback mike]

To clarify the connector has to have that white end to fit into he loom and two wires off it to go into the new speaker spade connectors :thumb up:

[normalbloke]

Just solder appropriate tails onto the joints either side of it. Usual rules apply, competent soldering,heat management and don't let the heat soak down to damage the speaker cone.

[silverback mike]

Competent soldering

[Craikeybaby]

Are you planning to refit the factory speakers? If not just chop the connectors off and solder to the Alpine speakers/ some spade connectors.

[jkh112]

Craikeybaby said:

Are you planning to refit the factory speakers? If not just chop the connectors off and solder to the Alpine speakers/ some spade connectors.

[silverback mike]

[David Beer]

Are they in a T arrangement ? If so I know of them.

[silverback mike]

Literally the ones I'm after David are the same as on the outgoing speaker, the white ones in the pic that connect to the male brown connector on the loom..

[David Beer]

I don't see a picture! Iam sure they will be the same as I know of. Can you send me pic, just to be sure