Aftermarket reversing camera - wiring
Discussion
I have an aftermarket reversing camera installed in my car - it's part of a Naviplus system and uses the display for that.
The camera has never really been that good and the mounting bracket was untreated mild steel which has now rusted away. I could probably fabricate a new bracket, but I think I'd rather take the opportunity to replace the camera. Rather than attempt to run another wire all the way from the boot to the centre console, am I likely to be able to just cut the old wire and splice the wire for a new camera straight into the old wire?
Assuming yes, are there any aftermarket reversing cameras that come highly recommended. From what I've seen they're not expensive, so I'm happy enough to take a punt if it will probably work.
The camera has never really been that good and the mounting bracket was untreated mild steel which has now rusted away. I could probably fabricate a new bracket, but I think I'd rather take the opportunity to replace the camera. Rather than attempt to run another wire all the way from the boot to the centre console, am I likely to be able to just cut the old wire and splice the wire for a new camera straight into the old wire?
Assuming yes, are there any aftermarket reversing cameras that come highly recommended. From what I've seen they're not expensive, so I'm happy enough to take a punt if it will probably work.
Gassing Station | In-Car Electronics | Top of Page | What's New | My Stuff