re scribing wonky panel line? help

[steveo3002]

right i had a go at making a panel line where there was nothing , it went a bit wrong and isnt good enough

now ive tried to fill it and re scribe , but the scribe falls back into the old wonky line rather than carve a new one

any ideas

[dr_gn]

steveo3002 said:

right i had a go at making a panel line where there was nothing , it went a bit wrong and isnt good enough

now ive tried to fill it and re scribe , but the scribe falls back into the old wonky line rather than carve a new one

any ideas

Use Dymo Tape stuck to the surface as a guide, or a flexible steel ruler taped to the surface. Make many light passes rather than one deep one. Been there - it's a bh.

[Skii]

mix superglue and talcum powder into a paste and dab it along the wonky bit. Sand it back, and then connect the panel line using a sharp blade, once you have scored the 'route' rescribe your panel line.

Job done.

Edited by Skii on Tuesday 20th September 12:27