Discussion
Found a video that I recorded back in the 90's (I Think) from ITV of the race at SPR where Rico suffered his blowover.
That set me to thinking.
There was a 'spate' of blowovers around that time, Garlits had two I think.
But then the problem went away.
Was it the aero packages that got better or some other design of the rails that stopped it happening?
That set me to thinking.
There was a 'spate' of blowovers around that time, Garlits had two I think.
But then the problem went away.
Was it the aero packages that got better or some other design of the rails that stopped it happening?
Technically, Rico's incident was a power wheelstand rather than a true Garlits/ Eddie Hill style Blowover. Both Gar's blowovers were a consequence of the 'spoon' shaped front end on the car which whilst great aerodynamically had the disadvantage that once air got underneath they acted in the same way as a cupped hand out of a car window. That style of car never caught on, probably for that precise reason.
Eddie Hills incident (featured on the 'decade of thrills' vids) was caused by the front wings slipping back from sloping down (causing downforce) to sloping up (causing lift). Presumably a more positive locking mechanism for the front wings resulted. In all those incidents caused by lift at speed (a true Blowover), there was absolutely nothing the driver could do to rescue the situation.
I have been told by people who know far more about these thing than I, that Rico's car was set for Bear, the clutch was quite aggressive, and more importantly he stayed on it far too long. He was travelling at relatively low speed, and had he got off it the car would have been saved. Several European racers (notably Lex Joon) have had the top frame rails parallel to the track, and got away with it.
FIA (and I imagine therefore NHRA) rules mandate the use of a wheelie bar in T/F now, and that would act to stop power wheelstands going right over.
I was always terrified what would happen if a car at SPR had a full on high speed Garlits / Hill blowover at the top end, and caught the chassis on the finish line gantry. Thankfully it would seem that the likelyhood of such an incident has receded.
Eddie Hills incident (featured on the 'decade of thrills' vids) was caused by the front wings slipping back from sloping down (causing downforce) to sloping up (causing lift). Presumably a more positive locking mechanism for the front wings resulted. In all those incidents caused by lift at speed (a true Blowover), there was absolutely nothing the driver could do to rescue the situation.
I have been told by people who know far more about these thing than I, that Rico's car was set for Bear, the clutch was quite aggressive, and more importantly he stayed on it far too long. He was travelling at relatively low speed, and had he got off it the car would have been saved. Several European racers (notably Lex Joon) have had the top frame rails parallel to the track, and got away with it.
FIA (and I imagine therefore NHRA) rules mandate the use of a wheelie bar in T/F now, and that would act to stop power wheelstands going right over.
I was always terrified what would happen if a car at SPR had a full on high speed Garlits / Hill blowover at the top end, and caught the chassis on the finish line gantry. Thankfully it would seem that the likelyhood of such an incident has receded.
Edited by Jon C on Thursday 30th October 18:45
I have also heard theorys from some noted tuners/crew chiefs that if the car is set too soft(for conditions) it is actually easier for the car to rotate around the axle than it is to spin the wheels hence the wheelstand.The top fuel car got bigger front wings as the 90s evolved so i guess the extra surface area was a help also they may have set the front wing attack a little more agressive when built?Its only a guess as im not really a dragster guy,Please dont take offence dragster people,im not after a pistonheads s
gging match
gging match
hellfish said:
I have also heard theorys from some noted tuners/crew chiefs that if the car is set too soft(for conditions) it is actually easier for the car to rotate around the axle than it is to spin the wheels hence the wheelstand.The top fuel car got bigger front wings as the 90s evolved so i guess the extra surface area was a help also they may have set the front wing attack a little more agressive when built?Its only a guess as im not really a dragster guy,Please dont take offence dragster people,im not after a pistonheads s
gging match
not so much in modern fuel racing. In the late 60's early 70's the tire tech and tracks caught up briefly with the power levels. With shorter cars the tendancy was for the pinion to climb the ringgear causing a wheelstand. Most modern blow over are as a result of drivers or wing strut failures.
gging match
is this the UK record holder for altitude achieved by a TF car?
and i was there....
http://www.eurodragster.com/news/features/roger_go...
and i was there....
http://www.eurodragster.com/news/features/roger_go...
veryoldfart said:
is this the UK record holder for altitude achieved by a TF car?
and i was there....
http://www.eurodragster.com/news/features/roger_go...
I should think Rico got higher thanks to a longer Wheelbase.and i was there....
http://www.eurodragster.com/news/features/roger_go...
mickey naylor was up ON the single wheelie bar wheel teetering left/right
came down with a right bang
lex joon's attempt...
http://uk.youtube.com/watch?v=mkMnuXEIeKo
came down with a right bang
lex joon's attempt...
http://uk.youtube.com/watch?v=mkMnuXEIeKo
Edited by veryoldfart on Friday 31st October 13:54
Edited by veryoldfart on Friday 31st October 13:55
Flying Toilet said:
veryoldfart said:
is this the UK record holder for altitude achieved by a TF car?
and i was there....
http://www.eurodragster.com/news/features/roger_go...
I should think Rico got higher thanks to a longer Wheelbase.and i was there....
http://www.eurodragster.com/news/features/roger_go...

veryoldfart said:
You took a nice bit of video there, Steve.The thing about blowovers is that when they happen, the car's usually wasted. Two notable exceptions to this are Eddie Hill, who fixed the car and carried on campaigning it on the NHRA tour and Rico, of course, who fixed the car and sent it to Brazil for demonstration purposes (I presume - please advise if not). Upon it's return to Europe, the car was campaigned by Peter Beck and later Rico had an extra seat added and thus the Top Fuel Taxi was born.
Back to blowovers, here is Randy Parks having a slight mishap at Phoenix a few years ago:- (turn your sound up)
http://www.nhra.com/movies99/race2/RParks1_99Phoen...
and:-
http://www.nhra.com/movies99/race2/RParks2_99Phoen...
That's Doug Kalitta in the other lane, by the way.
Gassing Station | Drag Racing | Top of Page | What's New | My Stuff


