Planet Ocean stopping, out of warranty
Planet Ocean stopping, out of warranty
Author
Discussion

Obiwonkeyblokey

Original Poster:

5,400 posts

271 months

Monday 10th September 2012
quotequote all
HI,

Ive got a PO which I purchased in Sept 2007 which I wear occasionally. recently its stopped for no apparent reason. I give it a wind in the morning, then within an hour it will have stopped then takes a while to get it going again.

My concern is that Ive only noticed this recently as I dont wear it very much and whether or not this could be a cripping bill.

A basic google search shows that a few people have had similar issues and the purpose of this post isn't to ask what to do ( as I need to take it to an AD) but to find out if anyone else has had similar issues and whether you manged to get them fixed.

Thanks

andy tims

5,606 posts

277 months

Monday 10th September 2012
quotequote all
It's 5 years old. Probably just needs a service.

Your AD will probably send it back to Bienne. I'd imagine Omega will charge in the £300 - £400 ball park unless it's the chronograph, which will probably be more. Someone with more recent experience with Omega may be better informed.

STS are Omega approved & may be slightly cheaper http://www.swisstimeservices.co.uk/

Alternatively, there are the independent watch repairers such as Genesis http://www.genesiswatchmaking.co.uk or Ryte Time http://www.rytetimewatchrepairs.co.uk/



Edited by andy tims on Monday 10th September 11:25

Ikemi

8,611 posts

236 months

Tuesday 11th September 2012
quotequote all
Obiwonkeyblokey said:
HI,

Ive got a PO which I purchased in Sept 2007 which I wear occasionally. recently its stopped for no apparent reason. I give it a wind in the morning

Thanks
How many turns of the crown do you do? For reference, you need to turn the crown a full 30-40 times for the watch to be fully wound, which should give you about 40hrs of power reserve! If you wear it on your wrist for the day, does it stop after an hour off the wrist?

Obiwonkeyblokey

Original Poster:

5,400 posts

271 months

Tuesday 11th September 2012
quotequote all
yes, thats about right. I would it about 20 times as thats what the dealer advised. ( i suppose im conscious of overwnding)

I wound it more this morning and so far so good.

okgo

42,376 posts

229 months

Tuesday 11th September 2012
quotequote all
Winding?

Mine wakes up after a little bit of movement, I've never needed to wind it...?

raptor600

1,356 posts

177 months

Tuesday 11th September 2012
quotequote all
okgo said:
Winding?

Mine wakes up after a little bit of movement, I've never needed to wind it...?
Maybe that's why it stops and you need to wake it up! wink

Arun_D

2,340 posts

226 months

Tuesday 11th September 2012
quotequote all
I was told to always wind to get an auto' movement (reliably) going from a dead stop. As per earlier post, I give my autos a good 30 winds or so. Apart from my 2009 Seiko Monster, which doesn't have a manual wind.

Edited by Arun_D on Tuesday 11th September 16:28

Ikemi

8,611 posts

236 months

Wednesday 12th September 2012
quotequote all
Obiwonkeyblokey said:
( i suppose im conscious of overwnding)
No worries ... You can't over wind a modern mechanical watch wink

AndrewWF

280 posts

173 months

Wednesday 12th September 2012
quotequote all
Obiwonkeyblokey said:
yes, thats about right. I would it about 20 times as thats what the dealer advised. ( i suppose im conscious of overwnding)

I wound it more this morning and so far so good.
Modern automatic watches have clutches to prevent overwinding, and usually take around 30 to 40 full rotations of the crown to reach maximum power reserve from empty. Mechanical movements use a variety of escapement mechanisms to stop the mainspring unwinding in one big explosion, but as the mainspring unwinds, the amount of potential energy reduces and the accuracy of the movement decreases until it no longer has the power to push the escapement through another cycle. If the movement is left to wind automatically and the mainspring has only a little energy stored in it, then it will appear to run slowly and will occasionally stop, waking up with a nudge of the wrist every now and then.

hilly10

7,543 posts

259 months

Wednesday 12th September 2012
quotequote all
I always send my Omegas to Omega UK direct cut out the AD mark up. I even had the watch tec ring me to discuss the problem with the watch

Obiwonkeyblokey

Original Poster:

5,400 posts

271 months

Thursday 13th September 2012
quotequote all
Thanks for your replies Gentelmen.

Over the last few days it continues to stop, however not as oftena s before. I will continue to wear it as a "daily" for a while to see its reliabilty improves and then send it off for a service once the Speedie comes back.

Obiwonkeyblokey

Original Poster:

5,400 posts

271 months

Monday 24th September 2012
quotequote all
update, took it to the states last week and ended up putting it back int he suitcase after two days of continually stopping. seems wind OK, but only works for maybe 90-120 mins at a time and then is a bugger to get going again. Will have to sent it off and hope for the best.