Mechanical question
Discussion
GC8 said:
My handwound Rolex is only taking twelve now - what does that suggest to you?
That 25 winds is incorrect. It isn't a set number for every movement, each mainspring is of a different length and tension and different kinds of movements require varied amounts of energy.You said only takes 12 winds NOW, did it used to be more and is now different?
GC8 said:
Not the clearest of posts... Yes Id expect it to have taken 25 when new, but its now taking only half that and the reserve is closer to 30hrs.
Accuracy is still good.
Interesting, I don't know much about older Rolex movements I guess it is nothing too much to worry about if the accuracy is still there. If it is over 5 years since it was serviced I would recommend getting that done. The mainspring is always replaced as a consumable part, providing you take it to a decent watch maker, ideally Rolex but I bet that would be pricey!Accuracy is still good.
Got a picture?
GC8 said:
Not the clearest of posts... Yes Id expect it to have taken 25 when new, but its now taking only half that and the reserve is closer to 30hrs.
Accuracy is still good.
The power reserve will naturally reduce over time as the spring looses resilience however the number of turns to fully wind the spring will not change. Accuracy is still good.
The turns to wind is dependent on the physical dimensions of the mainspring, the barrel and the gearing of the winding train so unless there is a physical change in one of those it should always take the same number of turns of the crown to wind.
Gassing Station | Watches | Top of Page | What's New | My Stuff





