Neck pickup not working
Neck pickup not working
Author
Discussion

Mr_S

Original Poster:

414 posts

228 months

Wednesday 30th November 2011
quotequote all
I have just replaced the pickups on my Strat and the neck pickup is not working.
If I switch to just the neck pickup I get no sound at all however if I tap the pickup I can hear noise the same as if I tap the middle or bridge pickups when switched to them.

I've had it in bits and restrung it twice now and still no luck,

Is there a way of testing the pickup without putting the strings on?

Edited by Mr_S on Wednesday 30th November 22:20

suthol

3,950 posts

263 months

Wednesday 30th November 2011
quotequote all
Mr_S said:
I have just replaced the pickups on my Strat and the neck pickup is not working.
If I switch to just the neck pickup I get no sound at all however if I tap the pickup I can hear noise the same as if I tap the middle or bridge pickups when switched to them.

I've had it in bits and restrung it twice now and still no luck,

Is there a way of testing the pickup without putting the strings on?

Edited by Mr_S on Wednesday 30th November 22:20
A tuning fork will do the trick for you.

Remember them biggrin

Mr_S

Original Poster:

414 posts

228 months

Thursday 1st December 2011
quotequote all
Thanks but I can't say i've ever had a tuning fork...

I guess i'll just take it out and see what it looks like on a meter.


Justin Cyder

12,624 posts

178 months

Thursday 1st December 2011
quotequote all
If you suspect the pickup may be a dud, you can test it and make sure it's good by touching the connections directly to a instrument cable that's plugged into an amp at low volume. Just un-solder the pickup wires from the controls and touch the green/bare to the sleeve of the 1/4" plug and the black to the tip and you should hear the pickup full power. If you don't get any sound then you might have a bad pickup.

Mr_S

Original Poster:

414 posts

228 months

Thursday 1st December 2011
quotequote all
Cheers i'll give that a try

Justin Cyder

12,624 posts

178 months

Thursday 1st December 2011
quotequote all
Doesn't help you if you want to keep the strings on I know, but it's a way of working things out. I put a SD Hotrail in my Parker P38 & went through three sets of strings before working out the wiring correctly. It's difficult full stop to put on & take off the pickguard & preserve the strings.

Mr_S

Original Poster:

414 posts

228 months

Thursday 1st December 2011
quotequote all
I found the problem, it was a broken coil wire on the neck pickup.

It's my fault too as I had kept them loose in a jiffy bag since I bought them and didn't really think how fragile that coil wire was.

At least only one got damaged.


Laplace

1,091 posts

211 months

Thursday 1st December 2011
quotequote all
Hope they weren't expensive pickups?

I was going to suggest a broken coil.
I had an intermittent neck pickup on my Strat and it was diagnosed by my tech tapping the pickup which made it cut in and out.


Mr_S

Original Poster:

414 posts

228 months

Thursday 1st December 2011
quotequote all
the neck pickup was only about £30 on ebay so not a disaster.

I could kick myself as i metered them when they arrived and they were fine but I just failed to look after them.