brake balance bar

[dilley]

Can anyone tell me if the main bolt that goes through the peddle/2xpush rods has a nut on both sides?? mine only has a nut on the right hand side and the whole threaded rod had come loose and had started to unwind!! I have tightened it up but seems like it needs a nut on the other end, good job I spotted it, could hqave been nasty!!

[RazMan]

The bias bar only needs to be fixed with a locknut on one side (whichever side is most accessable). It won't unwind completely - only change the bias from one end to the other.

Edited by RazMan on Sunday 24th June 10:56

[dilley]

nice to see you over here raz,

[andygtt]

It shouldn't really be unwinding at all.... I wonder if there is too much slack in it when it was assembled!

Am I right that you are near Cambridge?

[dilley]

I'm just outside of Cambridge.

[RazMan]

Well worth checking out Rally Design's guide for adjustment setup.
http://www.rallydesign.co.uk/catalog/balancebar.ph...

[andygtt]

There are a few of us around this part of the woods (including Raz), maybe we should sort a kinda meet.

[dilley]

We did have a meet down at the Barton Bull at 5 ways roundabout, it would be nice to organise another, it would be nice to have a ride over and see your project, it looks really good.

I think that snetterton show is soon??

Edited by dilley on Monday 25th June 20:53

[andygtt]

You'd be more than welcome... I even make a mean cup of coffee with which I'm hopeing I can entice Raz round this week (he's been invaluable with advice on my body design) to help me fit my new rear Wing... I'll come clean it's bigger than Waynes lol.

[RazMan]

andygtt said:

I'll come clean it's bigger than Waynes lol.

Boasting again ..... but very true
Andy, give me a shout when you need me

[dilley]

where abouts are you andy??

[andygtt]

I am near Sudbury about 45-50mins from south cambridge.

Raz, the spoiler is now due Thursday so it looks like Friday would be best.... I need to design the end plates as well. I can't wait to get it on and see what it looks like, hopeing for good weather so we can get it outside for some pics as all the wishbones etc go Sunday and it will be the last chance.

[dilley]

I am actually closer to Newmarket, nice route to where you are via Bury st Edmunds, I'll have to have a trundle over.

[andygtt]

Yes I know the road from Bury well, I had some fun on that in the canam....

I'll email you my tel number.

[Graham-P]

andygtt said:

You'd be more than welcome... I even make a mean cup of coffee with which I'm hopeing I can entice Raz round this week (he's been invaluable with advice on my body design) to help me fit my new rear Wing... I'll come clean it's bigger than Waynes lol.

Wot my elp not good enough!!!!!
Or is it that every time I come 'round I always seem to leave with some of your tools or parts from your cupboard to fit the CanAm